1. Contact factory for improved stabilities or additional product options. Not all options and codes are available at all
frequencies.
2. Unless other stated all values are valid after warm-up time and refer to typical conditions for supply voltage, frequency
control voltage, load, temperature (25°C).
3. Phase noise degrades with increasing output frequency.
4. Subject to technical modification.
5. Contact factory for availability.
For Additional Information, Please Contact
Vectron International
267 Lowell Road
Hudson, NH 03051
Tel: 1.888.328.7661
Fax: 1.888.329.8328
USA:
Vectron International
Landstrasse, D-74924
Neckarbischofsheim, Germany
Tel: +49 (0) 3328.4784.17
Fax: +49 (0) 3328.4784.30
Europe:
Vectron International
1F-2F, No 8 Workshop, No 308 Fenju Road
WaiGaoQiao Free Trade Zone
Pudong, Shanghai, China 200131
Tel: 86.21.5048.0777
Fax: 86.21.5048.1881
Asia:
Disclaimer
Vectron International reserves the right to make changes to the product(s) and or information contained herein without notice. No liability is assumed as a result of their use or application.
No rights under any patent accompany the sale of any such product(s) or information.
Looking for people who have worked on machine tool control software to work with, part-time is also acceptable! Required to make a machine tool control software, especially laser cutting machine softw...
Give me a QQ software that can be used under WINCE, for X86 platform, I used the source code of YQQ to compile, but there are too many problems, if you have successfully compiled it, can you tell me w...
Digitally controlled DCDC converter
1 Introduction :This design is a digital control DCDC converter . MCU is used to control the output voltage of the DCDC converter to achieve the purpose of digital ...
[i=s] This post was last edited by paulhyde on 2014-9-15 03:04 [/i] I am doing program control for problem D, using a single-chip microcomputer. The output voltage is sufficient, but there is almost n...
I have just been using Micropython for more than two weeks. In the past two weeks, I have mainly followed the documentation tutorials and run some programs. In my spare time on weekends, I used Visio ...