As shown in the figure above, the red box shows the combination of two op amps outputting a 1mA constant current to the RTD (PT100) below.My questions:
I don't quite understand the principle of how th...
[i=s] This post was last edited by paulhyde on 2014-9-15 09:15 [/i] NEC Cup Electronic Design Competition provides English information on the chip D78F1203 MCU...
The watchdog has three working modes: stop mode, timer mode, and watchdog mode. The control register WDTCTL consists of two parts. The upper 8 bits are used as passwords, and the lower 8 bits are used...
There is a 12-bit AD converter that converts analog quantity into digital quantity, and four seven-segment digital tubes are used to display the analog quantity. The unit machine uses an 8-bit 89C51, ...
To celebrate Chinese Valentine's Day! Post a help thread :pleased: Heroes! Do you have any recommendations for solutions for frequent long-distance wireless communication? The data transmission requir...
The proper f[size=1]LCD[/size] frequency depends on the LCD's frame frequency and the LCD multiplex rate and is calculated by: f[size=1]LCD[/size] = 2 × mux × f[size=1]Frame [/size]For example, to cal...
The rapid development of the Internet has realized high-speed information transmission and resource sharing, greatly facilitating people's lives. Embedded systems are widely used in various electr...[Details]
All electronic design engineers and scientists have performed electrical signal analysis, or signal analysis for short. Through this basic measurement, they can gain insight into signal details and...[Details]
introduction
Solar cells and LED lighting are typical applications of new energy and energy-saving and efficient technologies. Solar LED lighting uses solar cells to convert solar energy...[Details]
1. Introduction
At present, most lighting equipment still uses traditional energy for lighting. Making full use of solar energy as the energy supply for lighting equipment is of great si...[Details]
AD8205 is
a single-supply high-performance differential
amplifier
launched by
Analog
Devices of the United States
. The typical single-supply voltage is 5V, and its common-mode volta...[Details]
Overview:
This paper introduces a method of connecting a CAN-bus network with Ethernet to form a medium-sized remote monitoring/data transmission network.
CAN (Controller Area Network) is ...[Details]
1 Introduction
Building Automation System (BAS) is a distributed monitoring system (DCS) designed according to distributed information and control theory. It is the result of the mutual de...[Details]
1 Introduction
With the development of control, computer, communication, network technology, etc., a new control technology, namely fieldbus, has emerged in the field of industrial control...[Details]
Many battery-powered systems require a visual indicator to show when the battery needs to be replaced. LEDs are commonly used for this purpose, but they consume at least 10mA of current. This con...[Details]
Continuity test
A variety of devices need to be checked for continuity, including cable assemblies, printed circuit boards, and connectors to ensure that these components have the expected contin...[Details]
Only a small number of LED manufacturers can produce high-quality LEDs. For applications that are only used for simple indication, low-quality LEDs are sufficient. However, high-quality LEDs must...[Details]
1. Introduction
With the increasing popularity of fully automatic washing machines, consumers have higher and higher requirements for their environmenta...[Details]
1. Proposal of
reconfigurable
measurement and control system
The measurement and control system generally refers to a system based on
computers
to realize data acquisition a...[Details]
The DisplayPort interface standard is approved by the Video Electronics Standards Association (VESA) to provide an open, scalable standard for the entire industry. The development of DisplayPort ca...[Details]
A stepper motor is an electromagnetic mechanical device that converts an electrical pulse signal into an angular displacement or a linear displacement. The stability and reliability of a stepper mo...[Details]
Analog electronics
京公网安备 11010802033920号
EEWORLD
