-
On April 24, Sungrow released its annual financial report. The report shows that in 2017, Sungrow's global shipments reached 16.5GW, of which domestic shipments reached 13.2GW, a year-on-year incre...[Details]
-
UART has three operation modes: polling mode, interrupt mode and DMA mode. Chip: STM32F103C8T6 Application Pin: Output: PA0, PA1 USART1 Configuration interface Add interrupt configuration Add DMA...[Details]
-
This program mainly uses the comparison output function of the timer to generate PWM waves to control the LED. The comparison output of timer A corresponds to P2.3 P2.4. Therefore, a matching working...[Details]
-
1. Brief description A summary of "How to build uClinux kernel transplantation on ARMSYS development board with S3C44B0X as core", including the analysis of Bootloader function and the key co...[Details]
-
The implementation of CAN driver under embedded operating system Android requires not only adding CAN driver device in Linux kernel, but also implementing the call of Android HAL layer. Taking S5...[Details]
-
pre name="code" class="cpp" uint32_t ADC_Detect(uint32_t AD_Channel) { hadc.Instance- CHSELR = 0; ADC_ChannelConfTypeDef sConfig; sConfig.Channel = AD_Channel; sConf...[Details]
-
The analog watchdog of the ADC is used to check if the voltage is out of bounds. It has two upper and lower bounds, which can be set in the registers ADC_HTR and ADC_LTR respectively. The library fun...[Details]
-
Pin Definition FSMC configuration steps 1. Enable the corresponding pin GPIO clock 2. Configure the GPIO pin mode 3. Enable the FSMC clock 4. FSMC initialization 5. Memory block enable Examp...[Details]
-
Proteus simulation circuit diagram C language program #include absacc.h #include reg52.h #define DA0832 XBYTE #define uchar unsigned char #define uint unsigned int ...[Details]
-
Using AT89S51 microcontroller, modify the original one to turn the LED on for 4s and off for 2s. Thank you. Use a timer. (The program is written in the answer, omitted here - just a note) The origi...[Details]
-
Circuit: Using AT89S52 single chip microcomputer. P3.0 to P3.3 are connected to four external buttons. P3.4 to P3.7 are the bit selection ports for controlling the four digital tubes, and P1 is the s...[Details]
-
:For medium and large-scale domestic photovoltaic power stations, inverters generally go through an open bidding process. Due to the high technical content of power station design, it is necessary ...[Details]
-
Pay attention to whether the new lock matches the old door Smart locks have many advantages over traditional mechanical locks. Although the domestic penetration rate is not high, with the strength...[Details]
-
MSP430 MCU Stepper Motor Program #include "msp430x22x4.h" #define uchar unsigned char #define uint unsigned int uchar i=0; // Scanning 4x4 keyboard #define keyin (P2IN&0x0F) //digital tube v...[Details]
-
On January 29, according to Forbes magazine, many
storage
technologies and markets have been in the making for the past few years and will fully explode in 2018, which will have a huge impa...[Details]