After connecting the circuit according to the diagram, why is the high level output of LM393 only about 2.5V after the output is pulled up by 4.7k resistor? ?...
Abstract: This paper summarizes the four widely used single-chip reset circuits, establishes mathematical models for differential and integral reset circuits, and compares their reliability in use. It...
[i=s]This post was last edited by hello_mcu on 2021-8-9 22:26[/i]1. OverviewThis is my first time to experience silicon chips. I applied for the EFM32PG22 development board, which is very small but ha...
The nandflash driver in wince5.0 is divided into two layers: FAL+FMD. FMD is the interface function for nandflash, while the interface with the filesystem layer is implemented in the FAL layer. Where ...
[size=4] For AT89C52 to work, three circuits are essential, one is the clock circuit; the second is the reset circuit; the third is the power supply circuit. Today, I will take the STC89C52 microcontr...