EEWORLDEEWORLDEEWORLD

Part Number

Search

PH1-SI2SA4042

Description
Transponder, SC/UPC Connector,
CategoryWireless rf/communication    Optical fiber   
File Size240KB,6 Pages
ManufacturerJDS Uniphase Corporation ( VIAVI )
Websitehttp://www.jdsu.com/index.html
Download Datasheet Parametric View All

PH1-SI2SA4042 Overview

Transponder, SC/UPC Connector,

PH1-SI2SA4042 Parametric

Parameter NameAttribute value
Reach Compliance Codeunknown
Other featuresIT ALSO OPERATE FROM 1280NM TO 1600NM
body width56.1 mm
body height13.2 mm
Body length or diameter76.5 mm
Communication standardsGR-253, OC-192, SONET
Connection TypeSC/UPC CONNECTOR
Fiber optic equipment typesTRANSCEIVER, TRANSPONDER
Nominal operating wavelength1557 nm
Nominal optical power output1.122 mW
minimum return loss-27 dB
Base Number Matches1
COMMUNICATIONS MODULES & SUBSYSTEMS
10 Gb/s TDM/DWDM 300 Pin SFF MSA SR2/IR2/LR2 Transponder
PH1 Series
Key Features
• Three configurations supporting SR2/IR2/LR2 applications
• Supports dense wavelength division multiplexing
(DWDM) applications (without wavelocker)
• Microprocessor controls to support I2C
• Integrated 16:1/1:16 mux/demux
• Small form factor package (2.2" x 3.0" x 0.53") for high
density applications
• Low power consumption: 4.8 W typical, 6.8 W maximum
for TDM applications
• 70 °C maximum operating temperature
• High sensitivity PIN or APD receivers
• SONET, FEC, Ethernet and Multirate Capable Versions
• Forward, counter and line timing clocking modes
Applications
Telecommunications
Metropolitan Area Networks
Subscriber loop
Intra-office SONET/SDH
High bit-rate data communications
JDSU 10 Gb/s PH1 Series transponders are intended for 1550 nm system
applications with reaches of up to 80 km. The series includes three different
transponders for SR2 (25 km), IR2 (40 km), and LR2 (80 km) TDM or DWDM
applications. Each transponder accepts 16 bits of parallel digital data and converts
it to a 10 Gb/s NRZ modulated optical signal. It also accepts a 10 Gb/s NRZ
modulated optical signal and converts it into 16 bit wide parallel digital data.
The PH1 series offers low DC power dissipation and is available in either a small
form factor package (2.2 x 3 x 0.53 inches) or in a larger footprint (3.5 x 4.5 x 0.53
inches) package, depending on system thermal performance requirements. The
transmit design uses an Electro-Absorptive Modulated Laser (EML) which,
depending on the configuration, produces an average output power of between
-4 dBm to 2 dBm (EOL). A PIN (-17 dBm typical sensitivity) or APD (-24 dBm
typical sensitivity) receiver is available, based on system configurations.
JDSU PH1 Series transponders are designed to support the following data rates:
9.953 Gb/s (SONET), 10.3125 Gb/s (Ethernet), 10.664 Gb/s (FEC Encoded),
10.709 Gb/s FEC, or 11.09 Gb/s EFEC. They meet all applicable SONET/SDH standards.
Compliance
• Telcordia GR-253-Core
NORTH AMERICA
:
800 498-JDSU (5378)
WORLDWIDE
:
+800 5378-JDSU
WEBSITE
:
www.jdsu.com
Brief Analysis of Distributed Antenna System
[i=s]This post was last edited by jameswangsynnex on 2015-3-3 19:59[/i] Distributed Antenna System (DAS) is a network of multiple antennas distributed within a building specifically for providing wire...
dtcxn Mobile and portable
How to send commands to the lower computer in the upper computer written in Java?
I recently wrote a program for a host computer using Java, but I don't know how to send commands to the lower computer. Could you experts please give me some advice? Thank you in advance!...
yutianyunren Embedded System
Design of Asynchronous Serial Interface Keyboard Based on Single Chip Microcomputer 89C51
[align=center]Design of Asynchronous Serial Interface Keyboard Based on Single-Chip Microcomputer 89C51[/align] Source: Modern Electronic Technology Author: Yu Chengjun Han Zhenduo Ma Yanfei Abstract:...
SuperStar515 51mcu
What is the difference between industrial-grade WiFi chips and commercial-grade WiFi chips?
How big is the difference between industrial-grade wifi chips and commercial-grade wifi chips? Is it just that the working environment of wifi chips is different or the anti-interference performance o...
weiaa1911 Embedded System
Design and implementation of vehicle-mounted terminal based on GPS/GSM short message
In recent years, the real-time positioning technology of mobile vehicles based on GPS system and GSM wireless communication network has developed rapidly and is widely used in public security, fire pr...
szglmjh MCU
USB self-powered setup not working
I developed a device using omap, using a USB interface, setting the USB device to self-powered, and setting the maximum current to 100mA. After plugging it into a PC, it can get 300mA of current and c...
seawave2000 Embedded System

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

Robot
development
community

Index Files: 2895  556  690  1241  232  59  12  14  25  5 
Datasheet   0 1 2 3 4 5 6 7 8 9 A B C D E F G H I J K L M N O P Q R S T U V W X Y Z
Room 1530, 15th Floor, Building B, No. 18 Zhongguancun Street, Haidian District, Beijing Telephone: (010) 82350740 Postal Code: 100190
Copyright © 2005-2026 EEWORLD.com.cn, Inc. All rights reserved 京ICP证060456号 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号