MCJM1A-48P6Q9-0.5

For STM32, there are two ways to reset the software:   1) Use the official software library     The system reset function is directly provided in the stm32f10x_nvic.c file of the official software li...[Details]

Unlike three years ago, today's artificial intelligence is no longer just a floating concept, and the venture capital circle has begun to explore the various possibilities of this technolog...[Details]

    1. Introduction to MC68K CPU     The MC683xx series of microcontrollers are composed of the famous MOTOROLA 32-bit microprocessors such as MC68K, 68020, 68040, and the compatible 68K, CPU32, CPU3...[Details]

In 2018, the National Development and Reform Commission issued a new photovoltaic subsidy policy. The benchmark on-grid electricity price was significantly reduced, the return on investment decreased,...[Details]

Household photovoltaic power stations mainly utilize idle resources on existing household buildings, such as roofs, wall facades, balconies, courtyards, etc., to install and use distributed photovo...[Details]

Site conditions: 1. AD acquisition, DMA transmission; AD is set to single-channel continuous mode, DMA is set to single-shot mode. The upper threshold of the AD analog watchdog setting is less than t...[Details]

According to the description provided in the official manual of ST, it is not difficult to see that the ADC analog watchdog is actually that the user can set an upper and lower limit of the AD value...[Details]

Note: This STM32 microcontroller is the STM32F103 series. The ADC of Stm32 has DMA function. This is beyond doubt and is what we use most! However, if we want to sample a signal (such as a pulse sign...[Details]

ORG 0000H LJMP MAIN ORG 0003H LJMP TOINT ORG 001BH LJMP TOINT1 ORG 0030HMAIN: MOV SP,#60H      SETB IT0      SETB EX0      SETB EA      SJMP $TOINT:MOV TMOD,#10H      MOV TH1,#0FEH      MOV TL1...[Details]

;The hardware connection circuit of the 51 single-chip microcomputer is as follows: ;P1.3 and P1.4 are each connected to a button; ;P0.0 and P0.3 are each connected to a light-emitting diode; ;P2.0~P...[Details]

Assume that the MCS-51 microcontroller uses a 12MHz crystal oscillator, and wants to use a timer to generate a pulse with a duty cycle of about 30% and a period of 60ms at port P1.0. ;==============...[Details]

Please help me analyze the clock cycles occupied by the following delay program. Seek to explain: DELAY:  MOV  R6, #13 DELAY1: MOV  R5, #250 DELAY2: NOP         DJNZ  R5, DELAY2         DJNZ  R6, DEL...[Details]

//Environment: winavr+avr studio   char temp=0; ISR(TIMER1_COMPA_vect )//interrupt function {     // user code here     temp++;     if (temp==10)     temp=0;     PORTA=temp;     DDRA=0xff; } void ...[Details]

#include  #include "DS1302.h" #include    void ds1302_init(void) {     PORTX=0x00;     DDRX=0x07; }   void write_ds1302_byte(unsigned char dat) {          unsigned char i;     for(i=0;i 8;i++)     { ...[Details]

1. Analysis of the main causes of AVR damage:     The AVR circuit consists of three parts: the rectifier main circuit, the voltage detection circuit, and the comparison control circuit. Excluding the...[Details]