ZW-34-10-T-Q-450-055

On April 17, the U.S. Department of Commerce suddenly announced that it would completely ban U.S. companies from selling parts, goods, software and technology to ZTE within 7 years. This als...[Details]

0. Preparation First use st-link to connect the stm32 core board and PC for burning St-link Stm32 3.3V 3.3V GND GND SWDIO PART SWCLK DCLK Then connect with USB serial port board to v...[Details]

Autonomous driving and 5G are the two hot topics that global companies and media are paying the most attention to, and the combination of the two is the focus of everyone's attention....[Details]

I believe that many netizens who have watched "Interstellar" will remember this classic line, "Do not go gentle into this good night, nor let passion be drowned by the gloom of twilight". Different...[Details]

I used the bit definition in my 51 program: bit flag. After defining it this way, I ran the program and downloaded it to the circuit board. I found that the flag was not the value I set, which led to...[Details]

According to the description provided in the official manual of ST, it is not difficult to see that the ADC analog watchdog is actually that the user can set an upper and lower limit of the AD value...[Details]

The Vatican Secret Archives is one of the world's greatest historical collections, but many of its documents have never been transcribed. Recently, a project called Codice Ratio used a combination...[Details]

Interrupts and timers implement a 24-hour clock. The program is as follows: #include reg52.h   #define PORTLEN P0   sbit bit_select = P2^0; sbit seg_select = P2^1;   unsigned char src = {0x3f,0x06,0...[Details]

The key is the configuration of registers. The T1 timer (16 bits) of CC2530 needs to configure three registers: T1CTL, T1STAT, IRCON Here is just a brief introduction. For more details, please refer ...[Details]

In the 80C51 single-chip microcomputer, the clock frequency is known to be 6MHz. Please program P1.0 and P1.1 to output square waves with periods of 2s and 0.5s respectively. Please give the answer a...[Details]

MCS-51 single-chip microcomputer timer/counter experiment programming program Programming requirements: 1. Connect a light-emitting diode LED to the P1.0 pin, light up for two seconds, turn off for o...[Details]

Circuit: Using AT89S52 single chip microcomputer. P3.0 to P3.3 are connected to four external buttons. P3.4 to P3.7 are the bit selection ports for controlling the four digital tubes, and P1 is the s...[Details]

Please help me analyze the clock cycles occupied by the following delay program. Seek to explain: DELAY:  MOV  R6, #13 DELAY1: MOV  R5, #250 DELAY2: NOP         DJNZ  R5, DELAY2         DJNZ  R6, DEL...[Details]

//Note: The GCC-AVR version used in this article is WinAVR20100110 Interrupts are not part of the C language, and the implementation of interrupts is implemented by the compiler. Therefore, the writ...[Details]

The isp made a brief summary. Through online programming (the chip is programmed by continuously resetting the chip while the high voltage is converted), the MCU's flash, eeprom, fuse bits, encryptio...[Details]