69189-509

In most countries, the military is a fairly large group, and the health of soldiers is particularly important to the combat effectiveness of the army. The US Department of Defense's Advanced Resear...[Details]

    This paper combines embedded control technology with network control technology to realize the design of temperature control system based on single chip microcomputer through Internet control. Th...[Details]

1. Function and purpose         There are two pins BOOT0 and BOOT1 on each STM32 chip. The level status of these two pins when the chip is reset determines which area the program starts from after th...[Details]

This program sets the LED running light and the 0-16 numbers of the 0th position of the digital tube to light up in a cycle. The digital tube program cannot be put into the main function, because the...[Details]

#include reg52.h #define PORTLEN P0 sbit bit_select = P2^0; sbit seg_select = P2^1; unsigned char src = {0x3f,0x06,0x5b,0x4f,0x66,0x6d,0x7d,0x07,0x7f ,0x6f,0x77,0x7c,0x39,0x5e,0x79,0x71}; unsigne...[Details]

unsigned char num,i,j;                        unsigned char passwordtemp ; //Maximum input is 16      unsigned char inputtimes; //Number of incorrect password inputs      unsigned char passwordlength...[Details]

Program ideas and defects reference: 51 single chip microcomputer (AT89C52) matrix keyboard detection program #include iom16v.h   typedef unsigned char uchar;   typedef unsigned int uint;   #define ...[Details]

The single-chip microcomputer running light program requires all 32 serial ports to be used, and each serial port has eight LEDs.  Question supplement: The 8051 single-chip microcomputer is used, an...[Details]

A simple experimental programming question for the microcontroller: write a 3-byte binary addition subroutine. The program entry is: addend 1: 22H, 21H, 20H three bytes, 22H is the highest bit; adden...[Details]

MCU Programming: Find the average value of 8 unsigned numbers. There are 8 unsigned numbers stored in 8 units of the internal RAM starting at 20H. It is required to save their average value in R2. ;-...[Details]

In the 51 single-chip microcomputer's on-chip data memory units 20H and 21H, the data 9 and 2 are stored respectively. Write a program to calculate the difference and product between the two. The d...[Details]

1. Pin: 0 in 1 out  Set Status  Output status IO register setting          DDR×A certain bit is set to 1, and the corresponding bit IO is set to output;          PORT×A certain position is 1/0, and t...[Details]

　　 After three years of continuous decline in its mobile phone business, ZTE has finally revealed its true feelings to the outside world: the Chinese market is its weak point, and it is planning to f...[Details]

      For the STC89 series microcontrollers in PQFP-44 and PLCC-44 packages, 4 I/O ports P4 are added. The address of P4 port in the special function register is E8H, which can be bit addressed. User...[Details]

1. Question:   Should I choose AT89C51 or 89S51  when learning 51 series microcontrollers ? Answer: 89C51 and 89S51 have the same core. 89S51 has several obvious upgrades over 89C51 as follows:  ...[Details]