Embedded systems are undoubtedly one of the hottest and most promising IT application areas. Embedded systems are used on some specific dedicated devices. Usually, the hardware resources (such as proc...
The model of the quad 2-input NAND gate is CC4011. Please see the figure below for its pin function table. It has 4 NAND gates inside. I only used 3 of them in the circuit, namely 1, 2, and 4, and the...
How many RAM chips are needed to form a storage system using the following chips? How many bits of address are needed for off-chip address decoding? Assume that the system has 20-bit address lines and...
I risked my life to share the teacher's courseware with you. Last time, it was the first time to post it, so it was not very good. This time, I packaged all of them together. You can download them dir...
LinKIt ONELinkIt ONE that I got by chance years ago :pleased: This is my first time writing a review, I write it for fun, please point out if there is anything wrong :congratulate:LinKIt ONE:Introduct...
1 Introduction
The high temperature tester is mainly used for temperature tracking measurement and data acquisition during the heating process. By systematically analyzing the test data, the...[Details]
In recent years, lighting has become an important area that countries around the world are targeting to promote energy conservation and environmental protection. According to statistics, about 20% ...[Details]
With concerns about the growing energy crisis, motor efficiency has become an important and timely topic. This is because motors use 63% to 70% of the electricity produced in the United States and ...[Details]
Abstract: The output of high-range acceleration sensor is less than 10 mV under the excitation of small signal. The noise of traditional test system may cover such small voltage signal, so that hig...[Details]
Today, with energy becoming increasingly scarce, the utilization of natural energy has become the focus of people's attention. Among various natural energies, the endless solar energy is highly fav...[Details]
introduction
At present, the research on micron and nanotechnology is very active, which has led to the rapid development of microtechnology and micro-mechanical electronic system (MEMS) t...[Details]
Currently, high-frequency and high-efficiency DCDC converters are increasingly used in automotive electronic systems.
High switching frequency can use smaller power inductors and output filter...[Details]
introduction
The core features of mobile value-added service products are mobility, immediacy and personalization. Mobile value-added services are a new service mode that is rapidly developing...[Details]
1 Introduction
With the development of computer technology and information technology in the world, the global information age has arrived. All countries are formulating their own development p...[Details]
1 Introduction
Automatic Test
System The ATS (Automatic Test System) integrates all the stimulus and measurement equipment required for testing.
The computer
efficiently comp...[Details]
TPMS is the abbreviation of "Tire Pressure Monitoring System". It is mainly used to automatically monitor the tire pressure in real time when the car is driving, and to alarm for tire leakage and l...[Details]
The Portland Group, a leading provider of graphics processing units (GPUs) and graphics accelerators, has announced the availability of its PGI Accelerator™ Fortran and C compilers that support the...[Details]
0 Introduction
In microwave, radar, radio and television, and communication systems, the problem of coupling RF power is often encountered. A directional coupler is a directional power divide...[Details]
When programming in C and assembly, there are interface issues between variables and functions in C and assembly.
Variables defined in a C program are put into the .bss area after being compile...[Details]
The construction of voltage and current feedback amplifier application circuits is generally the same, except for a few key points.
Current feedback amplifiers have higher sl...[Details]