-
1. Purpose Since the number of times the STM32 FLASH can be erased and written is limited, in order to protect our FLASH and extend the use time of the MCU, we can debug on the SRAM. SRAM is a ...[Details]
-
UART has three operation modes: polling mode, interrupt mode and DMA mode. Chip: STM32F103C8T6 Application Pin: Output: PA0, PA1 USART1 Configuration interface Add interrupt configuration Add DMA...[Details]
-
0. Preparation First use st-link to connect the stm32 core board and PC for burning St-link Stm32 3.3V 3.3V GND GND SWDIO PART SWCLK DCLK Then connect with USB serial port board to v...[Details]
-
China Energy Storage Network News:
"As the world's first third-generation blockchain, Anda Chain, which has China's independent intellectual property rights, will be launched globally in the ...[Details]
-
Google may have foreseen the spread of artificial intelligence (
AI
) technology across apps, devices, and services, such as recognizing friends' faces in photos and giving smart speakers h...[Details]
-
The storage media corresponding to the three boot modes of STM32 are built-in to the chip, they are: 1. User Flash = Flash built into the chip 2.SRAM = RAM area built into the chip, which is the m...[Details]
-
Example analysis: (using DMA mode) mian function: extern __IO u16 ADC_ConvertedValue; //The voltage value converted by ADC is defined in the context of ADC1_Init() float ADC_ConvertedValueLocal; ...[Details]
-
1. What is PWM What is PWM? Professionally speaking, it is pulse width modulation. In layman's terms, it is the continuous output of high and low levels. For example, the microcontroller outputs...[Details]
-
The key is the configuration of registers. The T1 timer (16 bits) of CC2530 needs to configure three registers: T1CTL, T1STAT, IRCON Here is just a brief introduction. For more details, please refer ...[Details]
-
When the program starts running, light A turns on for 5 seconds, then turns off, light B turns on for 5 seconds, light B turns off, light C turns on for 5 seconds, light C turns off, the program ends...[Details]
-
/*----------------------------------------------- Name: Two-color dot matrix Forum: www.doflye.net Written by: shifang Modification: None Content: Using hc595 to drive two-color d...[Details]
-
MCS-51 single-chip microcomputer timer/counter experiment programming program Programming requirements: 1. Connect a light-emitting diode LED to the P1.0 pin, light up for two seconds, turn off for o...[Details]
-
;The hardware connection circuit of the 51 single-chip microcomputer is as follows: ;P1.3 and P1.4 are each connected to a button; ;P0.0 and P0.3 are each connected to a light-emitting diode; ;P2.0~P...[Details]
-
Please help me analyze the clock cycles occupied by the following delay program. Seek to explain: DELAY: MOV R6, #13 DELAY1: MOV R5, #250 DELAY2: NOP DJNZ R5, DELAY2 DJNZ R6, DEL...[Details]
-
The following comes from - "cortex-M3 Definitive Guide" Special function register group: Program Status Registers (PSRs or xPSRs) Interrupt mask register group (PRIMASK, FAULTMASK, and BASEPRI) ...[Details]
Microcontroller MCU
京公网安备 11010802033920号
EEWORLD
