Com335X: Manually create an SD card boot disk
Prerequisites to start:
* Com335x evaluation board (including power cord, serial port debugging cable, network cable)
* A PC with serial and network ports...
It can automatically indent syntax and automatically complete keywords. Finally, it can remember the input and automatically complete the words entered last time. Is there such a thing as VIM?...
[i=s] This post was last edited by mcu200689 on 2018-6-7 23:16 [/i] [b][color=#5E7384]This content was originally created by EEWORLD forum user [size=3]mcu200689[/size]. If you need to reprint or use ...
Via hole is also called through hole. In order to meet customer requirements, the through hole must be plugged. After a lot of practice, the traditional aluminum sheet plugging process is changed, and...
This is a comparator circuit, but I don't understand it. I am a newbie who has just come into contact with these. 1. What type of comparator is this? Is it a hysteresis comparator? 2. What should the ...
I encountered a very strange situation. The same code reads different clocks with R8025EJ03 and R8025Ex28 (I think it's just a different batch number). The 8025 reads once a second with J03 and it's c...
1. Introduction
Since the 1980s, with the continuous development of automotive electronic technology, there are more and more electronic control units in automobiles, such as electronic fuel i...[Details]
The Mobile Industry Processor Interface (MIPI) Alliance is an organization responsible for promoting the standardization of software and hardware in mobile devices. It has released the D-PHY specif...[Details]
All electronic design engineers and scientists have performed electrical signal analysis, or signal analysis for short. Through this basic measurement, they can gain insight into signal details and...[Details]
1 Introduction
Ultrasonic waves have strong directivity, slow energy consumption, and can propagate over long distances in a medium, so they are used for distance measurement. Ultrasonic detec...[Details]
1. Introduction
At present, most lighting equipment still uses traditional energy for lighting. Making full use of solar energy as the energy supply for lighting equipment is of great si...[Details]
Overview:
This paper introduces a method of connecting a CAN-bus network with Ethernet to form a medium-sized remote monitoring/data transmission network.
CAN (Controller Area Network) is ...[Details]
Many battery-powered systems require a visual indicator to show when the battery needs to be replaced. LEDs are commonly used for this purpose, but they consume at least 10mA of current. This con...[Details]
Continuity test
A variety of devices need to be checked for continuity, including cable assemblies, printed circuit boards, and connectors to ensure that these components have the expected contin...[Details]
Capacitors
are basic components in various electronic devices and are widely used for bypassing, coupling,
filtering
, tuning, etc. in electronic circuits. However, to use capacitors,...[Details]
The rectified DC voltage is then converted back to AC using power electronics such as insulated gate bipolar transistors.
The output voltage is switched on and off at a high frequency, control...[Details]
Traditional
virtual instruments
consist of a data acquisition
board
based on PCI bus and
corresponding software. However, with
the rapid development of
computer
network techno...[Details]
0 Introduction
There are many types of sensors, and the working principles, measurement targets and measurement environments of different types of sensors vary greatly. The corresponding detection s...[Details]
The demand for improved healthcare environments is endless, so medical imaging equipment with higher resolution is needed to better observe the human body. High resolution brings problems with sign...[Details]
Battery clamps, commonly known as battery connectors, come in two sizes depending on the thickness of the battery terminals. One is the battery clamp used on thick terminals, with a positive termin...[Details]