SN54LVTH182504AHV

The global PV inverter market will shrink from $6.3 billion in 2017 to $3.7 billion in 2022 due to falling prices, according to GlobalData. Global PV Inverter Market Value to Shrink to $3.7 Bil...[Details]

For 80,000 ZTE (000063.SZ) employees and more Chinese ICT (information and communication technology) industry practitioners, the news from across the ocean on the evening of April 16 kept t...[Details]

1. Problem When developing STM32 with IAR, I found that I could not print floating point numbers by redirecting printf to the serial port. The code is as follows:  The output is as follows:  It can...[Details]

In the actual project development process, we often need to get the running time of a section of code. The usual method is to use an oscilloscope to measure it. This blog post will use SysTick to acc...[Details]

Hardware platform: stm32F407Zet6 Software platform: stm32cubeMX 4.7+MDK5.14 Circuit connection: PE8-LED0, PE9-LED1, PE10-LED2, PE11-LED3 Step 1: Create a project using stm32cubeMX 1. Start the soft...[Details]

Timing and protocol are two key points in digital system debugging, and they are also where logic analyzers can play their most valuable role. How can we use a logic analyzer to quickly complete wiri...[Details]

What is SYSTICK: This is a 24-bit system tick timer, SysTick, with automatic reload and overflow interrupt functions. All microcontrollers based on the Cortex_M3 processor can obtain a certain time ...[Details]

In 2018, the National Development and Reform Commission issued a new photovoltaic subsidy policy. The benchmark on-grid electricity price was significantly reduced, the return on investment decreased,...[Details]

Independent watchdog (IWDG) and low power mode are often used in STM32 development. The watchdog is to detect and solve faults caused by software errors, and the low power mode is to enter sleep mode...[Details]

Introduction: As a power electronic device, the photovoltaic inverter mainly converts the direct current generated by the photovoltaic module into alternating current. Because there are thousands o...[Details]

Note: This STM32 microcontroller is the STM32F103 series. The ADC of Stm32 has DMA function. This is beyond doubt and is what we use most! However, if we want to sample a signal (such as a pulse sign...[Details]

/* Unfortunately, it cannot generate a standard 38kHz frequency square wave, there is a little error*/  #include reg51.h #define uchar unsigned char #define uint unsigned int  sbit Waveout=P1^0; //P...[Details]

#include reg52.h      #include intrins.h          //unsigned char segout ={0,1,2,3,4,5,6,7}; //8 columns   unsigned char segout ={0x01,0x02,0x04,0x08,0x10,0x20,0x40,0x80}; //8 columns   unsigned char...[Details]

As shown in the figure, the circuit is required to count and display the number of times the button is pressed. When the button is pressed once, the count value increases by 1 (it is required to accu...[Details]

Circuit: Using AT89S52 single chip microcomputer. P3.0 to P3.3 are connected to four external buttons. P3.4 to P3.7 are the bit selection ports for controlling the four digital tubes, and P1 is the s...[Details]