[i=s]This post was last edited by paulhyde on 2014-9-15 03:23[/i] Have you started working on the mechanical part? What materials are you going to use? The seat below must be very heavy, otherwise it ...
Currently need a good power supply to drive 14 series and 16 parallel fluorescent lamps 25W, MET certification is required
Who has a good power supply?
Or provide some information and knowledge about ...
[i=s]This post was last edited by paulhyde on 2014-9-15 08:59[/i] Does your MMC-1 chip have pwm output? ? ? Does your MMC-1 chip have pwm output? ? ? Does your MMC-1 chip have pwm output? ? ? If you c...
At present, there are a lot of coms, sharp, and modified Sony chips in the market. Personally, I feel that CMOS chips have very few peripheral components, high illumination SHARP chips, and impure col...
I am planning to DIY an ultrasonic module. Why does the CX20106A I bought have 9 pins? Aren't there usually 8? However, the first pin from the left on the side facing the chip with words has been cut ...