-
1. Purpose In actual product release, if the program stored in the MCU Flash is not protected, some illegal companies may read the program in the Flash through an emulator (J-Link, ST-Link, e...[Details]
-
UART has three operation modes: polling mode, interrupt mode and DMA mode. Chip: STM32F103C8T6 Application Pin: Output: PA0, PA1 USART1 Configuration interface Add interrupt configuration Add DMA...[Details]
-
Nowadays, everyone is saying that "technology is people-oriented". The essence of the development of technology is to serve the improvement of the quality of life of human beings. Automated driving...[Details]
-
Different from 51, AVR and other single-chip microcomputers, the clock signal sources of msp430 include LFXT1, XT2 and DCO. 1. LFXT1: It can connect high-speed and low-speed crystal oscillators. In l...[Details]
-
The implementation of CAN driver under embedded operating system Android requires not only adding CAN driver device in Linux kernel, but also implementing the call of Android HAL layer. Taking S5...[Details]
-
pre name="code" class="cpp" uint32_t ADC_Detect(uint32_t AD_Channel) { hadc.Instance- CHSELR = 0; ADC_ChannelConfTypeDef sConfig; sConfig.Channel = AD_Channel; sConf...[Details]
-
Ouster LiDAR OS-1 (left) and OS-2 (center) Velodyne invented the modern 3D LiDAR scanner in the mid-2000s, but in recent years conventional wisdom has held that Velodyne’s design — 64 lasers mounted...[Details]
-
Pin Definition FSMC configuration steps 1. Enable the corresponding pin GPIO clock 2. Configure the GPIO pin mode 3. Enable the FSMC clock 4. FSMC initialization 5. Memory block enable Examp...[Details]
-
Table of contents: 1 Overview 2: Common interrupt functions 3: PWM output 1 Overview In development, timers are widely used, which can be simply summarized into three aspects: 1.1: Application of ...[Details]
-
;Question: The 80C51 single-chip microcomputer has a fosc = 6MHz. It is required to use the T1 timer working mode 1 to perform a timing of 40ms. And P1.7 periodically outputs a rectangular wave with ...[Details]
-
Using AT89S51 microcontroller, modify the original one to turn the LED on for 4s and off for 2s. Thank you. Use a timer. (The program is written in the answer, omitted here - just a note) The origi...[Details]
-
/************************************************************************************* * main.c: the main file * NXP -- LPC1768 * * * Author : light *...[Details]
-
MSP430 MCU Stepper Motor Program #include "msp430x22x4.h" #define uchar unsigned char #define uint unsigned int uchar i=0; // Scanning 4x4 keyboard #define keyin (P2IN&0x0F) //digital tube v...[Details]
-
On January 29, according to Forbes magazine, many
storage
technologies and markets have been in the making for the past few years and will fully explode in 2018, which will have a huge impa...[Details]
-
From early June to November 2017, MSO 5 has been launched with a stunning temperament and appearance. From wider channel selection, more powerful functions, more fashionable touch screen, unprecedent...[Details]