[i=s]This post was last edited by fengke on 2021-3-31 16:20[/i]1. GPIO Introduction
GPIO (General-purpose input/output), short for general-purpose input and output, is a pin of a microcontroller that ...
The minimum system performance requirement for DSP5509 is the lowest, and it is OK to run a minimum program. For details, please add Q: 76777689, label: 5509. There will be a generous reward! I forgot...
[table][tr][td]It oscillates at about 50% duty, input 8V, output 4V; or input 15V, output 7.5V (rough estimate); there is no problem if the duty is lower or higher than this. Voltage mode, built-in ty...
Good blow, I'm a novice! I want to use a microcontroller to control the heat blocks and the like through relays. If I use a HK400F relay, can I directly connect it to 220V?
How do I connect those term...
The introduction looks very impressive, but I went to the official website to look for it, but couldn't find any information. It is said that this little guy uses Nordic's nRF52811 chip....
littleshrimpSpecial Edition for Assessment Centres
Calibrators are widely used in university experiments. Among them, there are two experiments in nuclear physics experiments in modern physics experiments (GM counter and β absorption) that require ...[Details]
Although improper medical device product design is not always associated with medical device-related errors. Studies of users have shown that lack of adequate training accounts for 70% to 90% of suc...[Details]
Magnetic resonance imaging (MRI) systems for medical and scientific applications require a high-performance, high-power inductor capable of establishing a uniform, strong magnetic field. Transverse el...[Details]
For more than 10 years, analog-to-digital converters (ADCs) have been widely used in industrial process control, medical instruments, communication systems, radar and other products as a booster of in...[Details]
Designers of hearing aids have stringent requirements. Hearing aids must be small enough to fit in or behind the ear, operate on ultra-low power, and be free of noise or distortion. To meet these requ...[Details]
TD-SCDMA terminal conformance test includes three types of tests: RF index test (reference standard: 3GPPTS34.122), protocol signaling test (reference standard: 3GPPTS34.123) and other tests (refer...[Details]
Signal sources have developed to a very wide range today. We can classify them according to the frequency range: ultra-low frequency (0.1m~1kHz), audio (20Hz~20kHz), video (20kHz~10MHz), radio fre...[Details]
The overcurrent and overheating coordinated protection technology implemented by polymer positive temperature coefficient devices (PPTC) can protect motors, controllers and electronic components in...[Details]
summary
Theoretically explains how to set up a PFC boost regulator using a current sensing transformer with the UCC3817 control IC.
1. Schematic
The schematic diagram is show...[Details]
A well-designed electronic load is not designed just for use in the lab; it should be carefully designed and built to test actual power systems. This is true for military portable systems, such as ...[Details]
1. Introduction
The UCC28051 reference design is a 100W offline AC/DC voltage converter with power factor correction (PFC). This power module design is intended to illustrate how to proper...[Details]
Introduction
Wireless operators are driving demand for broadband and data rates by offering enhanced data services to increase average revenue per user (ARPU). The need to provide users with ...[Details]
A correct circuit design cannot be manufactured 100% correctly when it is taken to the factory for manufacturing. It will always be affected by various uncertainties, such as deviations in manufact...[Details]
Industrial control
often requires multi-channel fault detection and multi-channel command control (this multi-task setting is very common). A single CPU chip is difficult to directly complete ...[Details]
Abstract:
A single pulse secondary radar reply processor implemented with EPLD. Its main functions include: reply frame pulse detection, reply information decoding, assembling reply inf...[Details]