Does anyone have relevant information on CRC hardware module IP design based on FPGA? ? ? I hope you can give me some advice and relevant information! Thank you very much!...
1. Once, the landlord asked me, did you eat anyting yet? I said no. After hearing this, she repeated it again, so u didn't eat anyting. I said yes... The old landlord hesitated and asked again, did yo...
The software used is Smart Flash Programmer2.
The simulation burning tool is XDS100V3.
The board programming port is VCC-GND-TMS-TCK-RESET. You can use it without RESET. Just connect the board to the ...
Dear experts, I encountered a problem when debugging the iic slave of stm8. When the host sends the device number and address, the slave responds to ack normally, but when the host starts to read data...
I don't know what's wrong with my program. CC1100 just can't configure registers and write values to registers! SpiWriteReg(CC1100_FSCTRL1, 0x08); SpiWriteReg(CC1100_FSCTRL0, 0x00); SpiWriteReg(CC1100...