Operating temperature range is as follows: –40 C to +85 C.
2
Datarates should be limited to adhere to edge of band requirements in accordance with ETSI 300-220
3
Frequency Deviation = (PFD Frequency Mod Deviation )/2
12
.
GFSK Frequency Deviation = (PFD Frequency 2
m)
/2
12
where
m
= Mod Control.
4
The output power is limited by the spurious requirements of ETSI at +55 C. The addition of an output filter (see Applications section) will allow increased output
levels to >10 dBm at both 433 MHz and 868 MHz
5
V
DD
= 3 V, PFD = 4 MHz, PA = 10 dBm
6
V
DD
= 3 V, Loop Filter BW = 100 kHz
7
V
DD
= 3 V, PFD = 4.42368 MHz, PA = 3 dBm
8
V
DD
= 3 V, Loop Filter BW = 100 kHz
9
These spurious levels are based on a maximum output power of +3 dBm for 868 MHz and +10 dBm for 433 MHz. It assumes a PFD frequency of <5 MHz.
Recommended PFD frequencies are 4.42368 MHz (22.1184/5) for 868 MHz, and 4 MHz for 433 MHz operation. Compliance for higher output powers will require
an external filter. See Applications section.
10
Not production tested. Based on characterization.
Specifications subject to change without notice.
REV. 0
–3–
ADF7011
TIMING CHARACTERISTICS
Parameter
t
1
t
2
t
3
t
4
t
5
t
6
Limit at
T
MIN
to T
MAX
(B Version)
10
10
25
25
10
20
(V
DD
= 3 V
10%; VGND = 0 V, T
A
= 25 C, unless otherwise noted.)
Unit
ns min
ns min
ns min
ns min
ns min
ns min
Test Conditions/Comments
DATA to CLOCK Setup Time
DATA to CLOCK Hold Time
CLOCK High Duration
CLOCK Low Duration
CLOCK to LE Setup Time
LE Pulsewidth
Guaranteed by design but not production tested.
Specifications subject to change without notice.
t
3
t
4
CLOCK
t
1
t
2
DATA
DB23 (MSB)
DB22
DB2
DB1
(CONTROL BIT C2)
DB0 (LSB)
(CONTROL BIT C1)
t
6
LE
t
5
Figure 1. Timing Diagram
ABSOLUTE MAXIMUM RATINGS
1, 2
(T
A
= 25°C, unless otherwise noted.)
NOTES
1
Stresses above those listed under Absolute Maximum Ratings may cause perma-
nent damage to the device. This is a stress rating only; functional operation of the
device at these or any other conditions above those listed in the operational
sections of this specification is not implied. Exposure to absolute maximum rating
conditions for extended periods may affect device reliability.
2
This device is a high performance RF integrated circuit with an ESD rating of
<1 kV and is ESD sensitive. Proper precautions should be taken for handling and
I'm a novice. I can't synchronize the BSL of MSP430F5171. The programming program I downloaded online doesn't support 5171. I don't know what's wrong now. . . . Help:surrender:...
Today is the Mid-Autumn Festival. Have you gone home for reunion? ? I wonder if those who went home for reunion were surrounded by gossiping women and urged to get married? :puzzle: It seems that when...
The contradictory code between class and interrupt in ADS c++ language is as follows: class time { public: friend void __irq timeUp(void); int timeCount; } void __irq timeUp() { timeCount=1;//There wi...
My computer was struck by lightning and the network card was damaged and I couldn't access the Internet. I added a separate network card and was able to access the Internet, but after a few days the c...
It is known that the content of the word unit at 21000h is BE00H. For the following program: mov ax,2000h mov ds,ax mov bx,1000h mov ax,[bx] inc bx inc bx mov [bx],ax inc bx inc bx mov [bx],ax inc bx ...
Microcontrollers (MCUs), which are widely used in automotive electronics, are rapidly facing time and cost pressures. The main advantage of using MCUs has always been to create high-level system in...[Details]
With the continuous improvement of the requirements of intelligent building security systems and the continuous improvement of people's safety awareness, indoor anti-theft has gradually attracted peop...[Details]
introduction
The emergence of high-performance, low-power embedded CPUs and high-reliability network operating systems has made it possible to implement applications with large amounts of comp...[Details]
Aromatic gases are widely present in food, medicine, cosmetics and various daily chemical products, such as snacks, liquor, spices, Chinese herbal medicines, plasters, perfumes, soaps, shampoos, et...[Details]
Since the No. 4 blast furnace of Handan Iron and Steel was put into operation in 1993, its external equipment has been seriously aged, and the original PLC control system TDC3000 of the hot blast furn...[Details]
1 Introduction
Water resources are the basic conditions for human survival and the lifeline of economic development. The reality shows that due to the global shortage of water resources and th...[Details]
Abstract: Aiming at the needs of coal-rock acoustic emission signal monitoring system, a data acquisition circuit with 24-bit resolution and 16-channel synchronous data acquisition function is desi...[Details]
LED technology has made rapid progress, and improvements in chip design and materials have promoted the development of brighter and more durable light sources, and the scope of light source applica...[Details]
System Overview
The system consists of a signal preprocessing circuit, a single-chip computer AT89C2051, a systematic LED display module, a serial port data storage circuit and system software...[Details]
Introduction
Nowadays, people pay more and more attention to the security alarm system, and people have higher and higher requirements for the functions and performance of the alarm. This paper prop...[Details]
Temperature compensated quartz crystal oscillator (TCXO) is widely used as a high-precision frequency source in communication systems, radar navigation systems, precision measurement and control sy...[Details]
Every time I go home and walk up the stairs, I am always scared. The corridor lights are often broken, and no one changes the bulbs, or they are not smart enough and need to be operated manually. E...[Details]
One in five car failures are caused by batteries, a problem that will become more serious in the coming years as electric-by-wire, start/stop engine management and hybrid (electric/gas) vehicles be...[Details]
The capacity of a battery depends on the amount of charge and discharge, in addition to some factors of the battery itself. Obviously, if the charge and discharge of the battery can be recorded all...[Details]
DCDC means DC to DC (conversion of different DC power values). Anything that meets this definition can be called a DCDC converter. Specifically, it means converting the input DC into AC through a s...[Details]
Microcontroller MCU
京公网安备 11010802033920号
EEWORLD
