Intelligent gas leak alarmAuthor: Blue AngelI got the board in late May and only adjusted the hardware and data collection. I didn't do Bluetooth and aap data upload. Now I will submit the completed p...
蓝色天使onsemi and Avnet IoT Innovation Design Competition
To ensure the full use of the Stellaris development board, and to hope that the "vanguard" of this time will strive for more opportunities to try out the board for the brothers in the forum through un...
LPS22HH is a high-precision air pressure sensor
24-bit resolution, can distinguish 0.024Pa air pressure changes
The noise can reach 0.65Pa when using the internal filter, which is better than the MPL3...
Conductive cloth tape is suitable for all kinds of electronic and electrical products such as computers, mobile phones, wires, cables, etc. It is mainly used to shield or isolate the interference of e...
LAN8720 configuration: IP: 192.168.192.30 Gateway: 192.168.192.1 A high frequency of ARP packets is detected The content of the packet asks for the mac address of 192.168.192.1, and asks the resp...[Details]
Function List and Notes (lower-level driver part) 1. IO port initialization: control IO and communication IO. Control includes power control, reset and low power mode. Communication is the serial po...[Details]
ZTE was punished, and Hou Weigui, who had already retired, had to come out of retirement again and run around to mediate. Let's follow the embedded editor to learn about the relevant content.
...[Details]
This paper combines embedded control technology with network control technology to realize the design of temperature control system based on single chip microcomputer through Internet control. Th...[Details]
Independent watchdog (IWDG) and low power mode are often used in STM32 development. The watchdog is to detect and solve faults caused by software errors, and the low power mode is to enter sleep mode...[Details]
The independent watchdog of STM32 is driven by a dedicated internal 40Khz low-speed clock, that is, it is still effective even if the main clock fails. Here we need to note that the clock of the inde...[Details]
A crystal oscillator can be electrically equivalent to a two-terminal network consisting of a capacitor and a resistor in parallel and a capacitor in series. In electrical engineering, this network h...[Details]
The clock system of STM32 can be directly summarized in a diagram (from the STM32F10X reference manual). The following is an analysis of this diagram 1. STM32 input clock source 1.1 Function of cl...[Details]
This program sets the LED running light and the 0-16 numbers of the 0th position of the digital tube to light up in a cycle. The digital tube program cannot be put into the main function, because the...[Details]
Requirements: Set timer T1 as an external event counter, count 500 pulses every time, then switch T1 to timing mode and output a positive pulse with a width of 10ms at P1.2. Over and over again. A...[Details]
According to a report by Russian News Agency on November 23, Alexander Hanin, founder and general manager of VisionLabs, a Russian facial recognition software development company, believes that in ...[Details]
In one of my products, there are two chips, AVR and PIC, at the same time. When AVR drives the relay, then drives the contactor. PIC is used for display. I found that PIC actually has a little interf...[Details]
Analogue and Mixed Signal
京公网安备 11010802033920号
EEWORLD
