EEWORLDEEWORLDEEWORLD

Part Number

Search

MICRF600

Description
IC RF MOD 868-870MHZ 11.5X14.1MM
Categoryunclassified   
File Size439KB,21 Pages
ManufacturerMicrochip
Websitehttps://www.microchip.com
Download Datasheet View All

MICRF600 Overview

IC RF MOD 868-870MHZ 11.5X14.1MM

MICRF600
902-928MHz ISM Band Transceiver
Module
General Description
The MICRF600 is a self-contained frequency shift keying (FSK)
transceiver module, intended for use in half-duplex, bidirectional
RF links. The multi-channeled FSK transceiver module is intended
for UHF radio equipment in compliance with the North American
Federal Communications Commission (FCC) part 15.247 and
249.
The transmitter consists of a fully programmable PLL frequency
synthesizer and power amplifier. The frequency synthesizer
consists of a voltage-controlled oscillator (VCO), a crystal
oscillator, dual modulus prescaler, programmable frequency
dividers, and a phase-detector. The output power of the power
amplifier can be programmed to seven levels. A lock-detect circuit
detects when the PLL is in lock.
In receive mode, the PLL synthesizer generates the local oscillator
(LO) signal. The N, M, and A values that give the LO frequency
are stored in the N0, M0, and A0 registers.
The receiver is a zero intermediate frequency (IF) type that makes
channel filtering possible with low-power, integrated low-pass
filters. The receiver consists of a low noise amplifier (LNA) that
drives a quadrature mix pair. The mixer outputs feed two identical
signal channels in phase quadrature. Each channel includes a
pre-amplifier, a third order Sallen-Key RC low-pass filter that
protects the following switched-capacitor filter from strong adjacent
channel signals, and a limiter. The main channel filter is a
switched-capacitor implementation of a six-pole elliptic low pass
filter. The cut-off frequency of the Sallen-Key RC filter can be
programmed to four different frequencies: 100kHz, 150kHz,
230kHz, and 350kHz. The I and Q channel outputs are
demodulated and produce a digital data output. The demodulator
detects the relative phase of the I and the Q channel signal. If the I
channel signal lags behind the Q channel, the FSK tone
frequency is above the LO frequency (data “1”). If the I channel
leads the Q channel, then the FSK tone is below the LO
frequency (data “0”). The output of the receiver is available on the
DataIXO pin. A receive signal strength indicator (RSSI) circuit
indicates the received signal level. All support documentation can
be found on Micrel’s web site at: www.micrel.com.
RadioWire
®
Module
Features
“Drop in” RF solution
Small size: 11.5x14.1mm
RF tested
FCC Compliant
Low Power
Surface Mountable
Tape & Reel
Digital Bit Synchronizer
Received Signal Strength Indicator (RSSI)
RX and TX power management
Power down function
Register read back function
Applications
Telemetry
Remote metering
Wireless controller
Remote data repeater
Remote control systems
Wireless modem
Wireless security system
RadioWire® is a trademark of Micrel, Inc
Micrel Inc. • 2180 Fortune Drive • San Jose, CA 95131 • USA • tel +1 (
408
) 944-0800 • fax + 1 (408) 474-1000 • http://www.micrel.com
July 2006
M9999-082505

Technical ResourceMore

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

Robot
development
community

Index Files: 489  1086  366  678  2097  10  22  8  14  43 
Datasheet   0 1 2 3 4 5 6 7 8 9 A B C D E F G H I J K L M N O P Q R S T U V W X Y Z
Room 1530, 15th Floor, Building B, No. 18 Zhongguancun Street, Haidian District, Beijing Telephone: (010) 82350740 Postal Code: 100190
Copyright © 2005-2026 EEWORLD.com.cn, Inc. All rights reserved 京ICP证060456号 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号