• All single cycle instructions (200 ns), except for
program branches which are two-cycle
• Operating speed:
- DC - 40 MHz clock input
- DC - 100 ns instruction cycle
Device
PIC16C620
PIC16C620A
PIC16CR620A
PIC16C621
PIC16C621A
PIC16C622
PIC16C622A
•
•
•
•
Program
Memory
512
512
512
1K
1K
2K
2K
Data
Memory
80
96
96
80
96
128
128
SSOP
RA2/AN2/V
REF
RA3/AN3
RA4/T0CKI
MCLR/V
PP
V
SS
V
SS
RB0/INT
RB1
RB2
RB3
•1
2
3
4
5
6
7
8
9
10
20
19
18
17
16
15
14
13
12
11
RA1/AN1
RA0/AN0
OSC1/CLKIN
OSC2/CLKOUT
V
DD
V
DD
RB7
RB6
RB5
RB4
Special Microcontroller Features:
• Power-on Reset (POR)
• Power-up Timer (PWRT) and Oscillator Start-up
Timer (OST)
• Brown-out Reset
• Watchdog Timer (WDT) with its own on-chip RC
oscillator for reliable operation
• Programmable code protection
• Power saving SLEEP mode
• Selectable oscillator options
• Serial in-circuit programming (via two pins)
• Four user programmable ID locations
PIC16C62X
Interrupt capability
16 special function hardware registers
8-level deep hardware stack
Direct, Indirect and Relative addressing modes
Peripheral Features:
• 13 I/O pins with individual direction control
• High current sink/source for direct LED drive
• Analog comparator module with:
- Two analog comparators
- Programmable on-chip voltage reference
(V
REF
) module
- Programmable input multiplexing from device
inputs and internal voltage reference
- Comparator outputs can be output signals
• Timer0: 8-bit timer/counter with 8-bit
programmable prescaler
CMOS Technology:
• Low power, high speed CMOS EPROM
technology
• Fully static design
• Wide operating range
- 2.5V to 5.5V
• Commercial, industrial and extended tempera-
ture range
• Low power consumption
- < 2.0 mA @ 5.0V, 4.0 MHz
- 15
µA
typical @ 3.0V, 32 kHz
- < 1.0
µA
typical standby current @ 3.0V
2003 Microchip Technology Inc.
DS30235J-page 1
PIC16C62X
Device Differences
Device
PIC16C620
(3)
PIC16C621
PIC16C622
(3)
(3)
Voltage Range
2.5 - 6.0
2.5 - 6.0
2.5 - 6.0
2.7 - 5.5
2.5 - 5.5
2.7 - 5.5
Oscillator
See
Note 1
See
Note 1
See
Note 1
See
Note 1
See
Note 1
See
Note 1
Process Technology
(Microns)
0.9
0.9
0.9
0.7
0.7
0.7
PIC16C620A
(4)
PIC16CR620A
(2)
PIC16C621A
(4)
PIC16C622A
(4)
2.7 - 5.5
See
Note 1
0.7
Note 1:
If you change from this device to another device, please verify oscillator characteristics in your application.
2:
For ROM parts, operation from 2.5V - 3.0V will require the PIC16LCR62X parts.
3:
For OTP parts, operation from 2.5V - 3.0V will require the PIC16LC62X parts.
4:
For OTP parts, operations from 2.7V - 3.0V will require the PIC16LC62XA parts.
DS30235J-page 2
2003 Microchip Technology Inc.
PIC16C62X
Table of Contents
1.0
General Description .................................................................................................................................................................. 5
Voltage Reference Module ..................................................................................................................................................... 43
9.0
Special Features of the CPU .................................................................................................................................................. 45
10.0 Instruction Set Summary ........................................................................................................................................................ 61
11.0 Development Support ............................................................................................................................................................. 75
13.0 Device Characterization Information ..................................................................................................................................... 109
14.0 Packaging Information .......................................................................................................................................................... 113
Index ............................................................................................................................................................................................... 121
On-Line Support ................................................................................................................................................................................ 123
Systems Information and Upgrade Hot Line ..................................................................................................................................... 123
Product Identification System ........................................................................................................................................................... 125
TO OUR VALUED CUSTOMERS
It is our intention to provide our valued customers with the best documentation possible to ensure successful use of your Micro-
chip products. To this end, we will continue to improve our publications to better suit your needs. Our publications will be refined
and enhanced as new volumes and updates are introduced.
If you have any questions or comments regarding this publication, please contact the Marketing Communications Department via
E-mail at
docerrors@mail.microchip.com
or fax the
Reader Response Form
in the back of this data sheet to (480) 792-4150.
We welcome your feedback.
Most Current Data Sheet
To obtain the most up-to-date version of this data sheet, please register at our Worldwide Web site at:
http://www.microchip.com
You can determine the version of a data sheet by examining its literature number found on the bottom outside corner of any page.
The last character of the literature number is the version number, (e.g., DS30000A is version A of document DS30000).
Errata
An errata sheet, describing minor operational differences from the data sheet and recommended workarounds, may exist for current
devices. As device/documentation issues become known to us, we will publish an errata sheet. The errata will specify the revision
of silicon and revision of document to which it applies.
To determine if an errata sheet exists for a particular device, please check with one of the following:
• Microchip’s Worldwide Web site; http://www.microchip.com
• Your local Microchip sales office (see last page)
• The Microchip Corporate Literature Center; U.S. FAX: (480) 792-7277
When contacting a sales office or the literature center, please specify which device, revision of silicon and data sheet (include
literature number) you are using.
Customer Notification System
Register on our web site at
www.microchip.com/cn
to receive the most current information on all of our products.
[size=6]FET430UIF writer V2 upgrades to V3. The port name of the V2 version writer is MSP-FET430UIF-VCP, and the port name of the V3 version writer is MSP-FET430UIF-CDC. The drivers of the two version...
One of my programs has errors when I use @near to modify the structure, but no errors when I don't (put it in the first 256 bytes). I checked the space of @near and found that there is still a lot of ...
I joined Freescale in my sophomore year with no experience.[b][color=#5E7384]This content was originally created by EEWORLD forum user [size=3]Eat Out Fat Man[/size]. If you want to reprint or use it ...
There is a Comparator_A on 430, which can simulate the voltage comparison input. When I read the introduction of this comparator user manual, it says that the comparator output can be provided to the ...
I have vs2008 installed on my computer, then I downloaded an SDK, installed it, and used VS2008 to make a simple interface, which can run in the simulated wince6.0 of the local computer, but it cannot...
Assume that data is read from 8-bit AD (if it is a higher-bit AD, the data type can be defined as int), the subroutine is get_ad();
1. Limited secondary filtering
/* A value can be adjust...[Details]
1. Introduction
Since the 1980s, with the continuous development of automotive electronic technology, there are more and more electronic control units in automobiles, such as electronic fuel i...[Details]
Remote keyless entry (RKE) systems have become popular with users, with more than 80% of new cars in North America and more than 70% in Europe equipped with RKE systems. In addition to the obvious ...[Details]
Floating-point digital signal processing has become a constant requirement for precision technology, often in applications requiring high accuracy in areas such as aviation, industrial machinery, a...[Details]
1 Introduction
Solar street lights are mainly composed of four parts: solar photovoltaic cell components, batteries, charge and discharge controllers, and lighting fixtures. The bo...[Details]
Images in science fiction movies often break through the limits of reality, such as in the movie "Minority Report." Tom Cruise uses a multi-touch screen to browse information. Capacitive sensing te...[Details]
Xiaomi, a well-known Internet phone in mainland China, won a million-unit order contract from China Unicom on November 20 last year, which made Xiaomi famous in mainland China. In April this year...[Details]
Overview
In spectral measurement, photomultiplier tubes (PMT) and charge-coupled devices (CCD) are often used as photoelectric converters. PMT is used in slow-changing, high-precision spectral...[Details]
With concerns about the growing energy crisis, motor efficiency has become an important and timely topic. This is because motors use 63% to 70% of the electricity produced in the United States and ...[Details]
Introduction
In industrial control, speed measurement is often required. Generally, a contact tachometer is used. This tachometer must be placed against the center of the shaft to measure. It...[Details]
0 Introduction
There are many types of sensors, and the working principles, measurement targets and measurement environments of different types of sensors vary greatly. The corresponding detection s...[Details]
Fruit planting is an important part of China's agricultural development, and fruit tree pest control operations are becoming more and more important. At present, the overall level of pesticide applica...[Details]
The demand for improved healthcare environments is endless, so medical imaging equipment with higher resolution is needed to better observe the human body. High resolution brings problems with sign...[Details]
Battery clamps, commonly known as battery connectors, come in two sizes depending on the thickness of the battery terminals. One is the battery clamp used on thick terminals, with a positive termin...[Details]
Electrostatic coupling and interference occur when a charged object is close to the input of the circuit being measured. At low impedance, the effects of interference are not noticeable because th...[Details]
Microcontroller MCU
京公网安备 11010802033920号
EEWORLD
