57M-111R

0. Preparation First use st-link to connect the stm32 core board and PC for burning St-link Stm32 3.3V 3.3V GND GND SWDIO PART SWCLK DCLK Then connect with USB serial port board to v...[Details]

Autonomous driving and 5G are the two hot topics that global companies and media are paying the most attention to, and the combination of the two is the focus of everyone's attention....[Details]

    With the development of information technology, intelligence, informatization and networking have become the development trend of modern industrial control. Since the 1980s, the rapid development...[Details]

The storage media corresponding to the three boot modes of STM32 are built-in to the chip, they are:  1. User Flash = Flash built into the chip   2.SRAM = RAM area built into the chip, which is the m...[Details]

The key is the configuration of registers. The T1 timer (16 bits) of CC2530 needs to configure three registers: T1CTL, T1STAT, IRCON Here is just a brief introduction. For more details, please refer ...[Details]

When the program starts running, light A turns on for 5 seconds, then turns off, light B turns on for 5 seconds, light B turns off, light C turns on for 5 seconds, light C turns off, the program ends...[Details]

/*-----------------------------------------------     Name: Two-color dot matrix     Forum: www.doflye.net     Written by: shifang     Modification: None     Content: Using hc595 to drive two-color d...[Details]

In the 80C51 single-chip microcomputer, the clock frequency is known to be 6MHz. Please program P1.0 and P1.1 to output square waves with periods of 2s and 0.5s respectively. Please give the answer a...[Details]

MCS-51 single-chip microcomputer timer/counter experiment programming program Programming requirements: 1. Connect a light-emitting diode LED to the P1.0 pin, light up for two seconds, turn off for o...[Details]

//Note: The GCC-AVR version used in this article is WinAVR20100110 Interrupts are not part of the C language, and the implementation of interrupts is implemented by the compiler. Therefore, the writ...[Details]

#include iom16v.h   #include macros.h #include "key.h" #include "1602.h" #include "delay.h" unsigned char display ={0,0,0}; //display data void main(void) {  unsigned char Key;    LCD_init();  ...[Details]

What is an AVR microcontroller? What are the advantages of an AVR microcontroller? Why should you choose an AVR microcontroller? AVR microcontroller is a new type of microcontroller developed by ATME...[Details]

　　According to the design requirements, the maximum voltage gain ≥ 60dB is achieved within a wide signal bandwidth (0-10MHz), and the ability to continuously adjust the gain or preset the gain in 5dB...[Details]

#include "MSP430x44x.h"  void init_UART(void);  void uart_start(void);  void uart_send(void);  void uart_receive(void);  unsigned char RXDATA_BUF ,TXDATA_BUF ={0xbd,0x77,0x3d,0xc5,0xc6,0xf5,0x68,0x0d...[Details]

/*34864 Chinese character library*/  //   Connection of  MCU //********************************************************  //p3= data port  //p4--control port//  p4.0  = rs //p4.1= r/w  //p4.2= e  //...[Details]