[i=s] This post was last edited by Aguilera on 2019-2-25 22:00 [/i] [size=4] To introduce the push-pull circuit, we first introduce some basic knowledge of the power amplifier. From the perspective of...
Please give me some advice:I need to develop a project now, using TMS320C5502 to connect to SDRAM (HY57V161610ET) through EMIF. How to write or read data when writing the program?...
My project is to make a digital CD player. My instructor asked me to use the wince kernel, but my development board does not have the data and burning tools under wince. But I have to graduate first. ...
After compiling with Quartus 2, an SDF file is generated. Then the timing back-annotation file is added to Modelsim and post-simulation is performed according to the steps. However, when viewing the w...
[i=s]This post was last edited by paulhyde on 2014-9-15 04:10[/i]The registration machine is divided into three parts, namely Part A, Part B, and Part C.
The software supported by this registration ma...
In the actual project development process, it is common to encounter modifications to the hardware circuit, and then the modified part requires the modification of the driver. Thinking about the comi...[Details]
I recently upgraded MDK to V5.25 and found that there are many libraries in the Managing Run-Time Environment. Compared with the past, it is much better, from the bottom-level driver to the upper-le...[Details]
Using Systick timer to achieve delay 1. SysTick timer characteristics The SysTick timer is a 24-bit down counter, that is, when vlue is decremented to 0, an interrupt is triggered and the load va...[Details]
Function List and Notes (lower-level driver part) 1. IO port initialization: control IO and communication IO. Control includes power control, reset and low power mode. Communication is the serial po...[Details]
1. Initial understanding of FSMC: FSMC consists of 4 modules: (1) AHB interface (including FSMC configuration register) (2) NOR flash memory and PSRAM controller (when driving LCD, LCD is like a PSRA...[Details]
The implementation of CAN driver under embedded operating system Android requires not only adding CAN driver device in Linux kernel, but also implementing the call of Android HAL layer. Taking S5...[Details]
In 2018, the National Development and Reform Commission issued a new photovoltaic subsidy policy. The benchmark on-grid electricity price was significantly reduced, the return on investment decreased,...[Details]
Introduction: As a power electronic device, the photovoltaic inverter mainly converts the direct current generated by the photovoltaic module into alternating current. Because there are thousands o...[Details]
The photovoltaic industry has become a new business card for China to the world. It not only represents China's leading technology, but also constantly breaks various records with its development spee...[Details]
If you do not use an external crystal on the STM32, the connection method of OSC_IN and OSC_OUT If you use the internal RC oscillator instead of an external crystal, please follow the following metho...[Details]
Using AT89S51 microcontroller, modify the original one to turn the LED on for 4s and off for 2s. Thank you. Use a timer. (The program is written in the answer, omitted here - just a note) The origi...[Details]
;The hardware connection circuit of the 51 single-chip microcomputer is as follows: ;P1.3 and P1.4 are each connected to a button; ;P0.0 and P0.3 are each connected to a light-emitting diode; ;P2.0~P...[Details]
Analogue and Mixed Signal
京公网安备 11010802033920号
EEWORLD
