The internal and external clocks that Msp430 can use are LFXT1 ( low-frequency, low-power clock, which can use an external low-frequency 32768HZ crystal oscillator or 400K-16M crystal oscillator ) , X...
[i=s]This post was last edited by lingking on 2019-5-25 23:06[/i] Recently, there has been a lot of news about the US crackdown on Huawei, DJI, and Hikvision, including the banning of chips and the su...
The pipeline can only perform at its maximum efficiency when it is filled with instructions, that is, one instruction is executed per clock cycle ( only single-cycle instructions ) .If the program jum...
1. Special treatment and special design of FPC soft board reinforcement can make the reinforcement not only play the function of component support, but also be designed as an auxiliary component devic...
[font=楷体, 楷体_GB2312][size=5]I believe that many people are using versions 5.5 and below, and cannot download programs for MSP430FR5969 normally. Now the method is here. Just replace a file and you can...
In the previous post, we analyzed the factory's initialization configuration process for NodeMCU-BU01 by reading the code, and located the specific implementation of AT command parsing and running and...
Hardware designers have begun to adopt FPGA technology in high-performance DSP designs because it can provide 10-100 times faster computing than PC-based or microcontroller-based solutions. Previou...[Details]
1 Introduction
The high temperature tester is mainly used for temperature tracking measurement and data acquisition during the heating process. By systematically analyzing the test data, the...[Details]
Analog engineers have traditionally struggled with complexity when designing power supplies that required multiple outputs, dynamic load sharing, hot-swap, or extensive fault-handling capabilities....[Details]
introduction
In the discharge process of tokamak plasma physics, the study of rupture and sawtooth is of great significance. Rupture and sawtooth exist in most tokamaks. Rupture is a notew...[Details]
All electronic design engineers and scientists have performed electrical signal analysis, or signal analysis for short. Through this basic measurement, they can gain insight into signal details and...[Details]
The reason for the light decay of white LEDs: the decline of phosphor performance
So far, the rapid decline of the luminous performance of white light LEDs, especially low-power white light LE...[Details]
1 Introduction
As an emerging microfabrication technology, micro-electromechanical system (MEMS) technology has begun to be applied in various fields. It can integrate functions such as inform...[Details]
1. Introduction
At present, most lighting equipment still uses traditional energy for lighting. Making full use of solar energy as the energy supply for lighting equipment is of great si...[Details]
1. System Structure
This system is a simulation system of indoor air-conditioning temperature/humidity control system. The data acquisition and control center collects temperature/humidity...[Details]
Overview:
This paper introduces a method of connecting a CAN-bus network with Ethernet to form a medium-sized remote monitoring/data transmission network.
CAN (Controller Area Network) is ...[Details]
Flooded Batteries
This battery developed in Germany can be used to power flashlights, strobe lights and toys as long as it is filled with water. This battery can be stored for 50 years and can...[Details]
Many battery-powered systems require a visual indicator to show when the battery needs to be replaced. LEDs are commonly used for this purpose, but they consume at least 10mA of current. This con...[Details]
As a simple and practical input device, buttons have been used in various microcontroller application systems and are ubiquitous. However, the buttons used in different practical occasions are also...[Details]
Introduction
Liquid crystal, as a display device, is widely used in low-power products such as instruments, meters, and electronic equipment with its unique advantages. In the past, the displ...[Details]