APL5546-BKI-TRL

1. Principle 1. Infrared emission protocol There are many infrared communication protocols. This experiment uses the NEC protocol. This protocol uses PWM modulation and uses pulse width to represen...[Details]

1. Purpose         In actual product release, if the program stored in the MCU Flash is not protected, some illegal companies may read the program in the Flash through an emulator (J-Link, ST-Link, e...[Details]

Today, under the guidance of a low-level expert, I learned how to configure the PWM module! Woof! First open the file configured last time, as follows:  Then, we need to use TIM1 to set PWM:  Then,...[Details]

UART has three operation modes: polling mode, interrupt mode and DMA mode. Chip: STM32F103C8T6 Application Pin: Output: PA0, PA1 USART1 Configuration interface Add interrupt configuration Add DMA...[Details]

Superconductors have physical properties such as zero resistance effect, Meissner effect and Josephson effect, which make them have broad application prospects and unparalleled advantages in many b...[Details]

　　Nowadays, everyone is saying that "technology is people-oriented". The essence of the development of technology is to serve the improvement of the quality of life of human beings. Automated driving...[Details]

Recently, Zhejiang Lipu Crushing Equipment Co., Ltd. invested 50 million yuan to build a new "annual production of 1,200 high-efficiency and energy-saving ultra-fine pulverizer construction project...[Details]

On May 16, in response to the public opinion storm caused by Lenovo's " 5G voting" incident, Lenovo Holdings Chairman and Lenovo Group Founder Liu Chuanzhi, Lenovo Gr...[Details]

ADC Introduction:     ADC (Analog-to-Digital Converter). That is, converting analog signals into digital signals for processing. When storing or transmitting, analog-to-digital converters are almost ...[Details]

Note: This STM32 microcontroller is the STM32F103 series. The ADC of Stm32 has DMA function. This is beyond doubt and is what we use most! However, if we want to sample a signal (such as a pulse sign...[Details]

Circuit: Using AT89S52 single chip microcomputer. P3.0 to P3.3 are connected to four external buttons. P3.4 to P3.7 are the bit selection ports for controlling the four digital tubes, and P1 is the s...[Details]

Recently, the National Development and Reform Commission announced that all foreign equity restrictions in the automobile industry will be lifted in the next five years. At the same time, as subsid...[Details]

/*************************************************************************************       *   main.c:  the main file    *   NXP -- LPC1768   *   *      *   Author  :   light                      *...[Details]

#include avr/io.h          #include util/delay.h #include avr/interrupt.h //Interrupt function header file //Function declaration void Port_Init(void); //Port initialization configuration void Comp...[Details]

#include  #include "DS1302.h" #include    void ds1302_init(void) {     PORTX=0x00;     DDRX=0x07; }   void write_ds1302_byte(unsigned char dat) {          unsigned char i;     for(i=0;i 8;i++)     { ...[Details]