1-1775855-1

In the actual project development process, it is common to encounter modifications to the hardware circuit, and then the modified part requires the modification of the driver. Thinking about the comi...[Details]

1. The first project We are going to create the first project, which is mainly for project analysis, so that we can understand how CubeMX works and how to trace the code logic. Okay, no more nonsense...[Details]

Function List and Notes (lower-level driver part) 1. IO port initialization: control IO and communication IO. Control includes power control, reset and low power mode. Communication is the serial po...[Details]

1. Initial understanding of FSMC: FSMC consists of 4 modules: (1) AHB interface (including FSMC configuration register) (2) NOR flash memory and PSRAM controller (when driving LCD, LCD is like a PSRA...[Details]

    1 Introduction     Due to the special working environment of coal mine production, the production process is more dangerous and unsafe than the general industry. With the continuous increase in c...[Details]

Every era has anxiety that has nowhere to go. Let's follow the embedded editor to learn about the relevant content. The anxiety of the post-Internet era is that if you don’t revolutionize ...[Details]

    //Observe the difference between feeding the dog and not feeding the dog, and use the LED indicator of the PB port for status indication.     //Switch the LED indicator enable switch of the PB po...[Details]

According to the description provided in the official manual of ST, it is not difficult to see that the ADC analog watchdog is actually that the user can set an upper and lower limit of the AD value...[Details]

The analog watchdog of the ADC is used to check if the voltage is out of bounds. It has two upper and lower bounds, which can be set in the registers ADC_HTR and ADC_LTR respectively. The library fun...[Details]

environment: Host: XP Development environment: MDK4.23 MCU:STM32F103CBT6 illustrate: Collect AD through pins PA1 and PA2. Collect AD 10 times for each channel. #include "ad_driver.h"      //Global ...[Details]

Proteus simulation circuit diagram C language program #include  absacc.h    #include  reg52.h       #define DA0832 XBYTE       #define uchar unsigned char   #define uint unsigned int     ...[Details]

Program ideas and defects reference: 51 single chip microcomputer (AT89C52) matrix keyboard detection program #include iom16v.h   typedef unsigned char uchar;   typedef unsigned int uint;   #define ...[Details]

The single-chip microcomputer running light program requires all 32 serial ports to be used, and each serial port has eight LEDs.  Question supplement: The 8051 single-chip microcomputer is used, an...[Details]

A simple experimental programming question for the microcontroller: write a 3-byte binary addition subroutine. The program entry is: addend 1: 22H, 21H, 20H three bytes, 22H is the highest bit; adden...[Details]

Requirements: Set timer T1 as an external event counter, count 500 pulses every time, then switch T1 to timing mode and output a positive pulse with a width of 10ms at P1.2. Over and over again. A...[Details]