EEWORLDEEWORLDEEWORLD

Part Number

Search

SY244THCD-6X601U629U4602

Description
Rocker Switch, DP3T, Latched, 0.02A, 20VDC, Solder Terminal, Rocker Actuator, Through Hole-straight
CategoryMechanical and electronic products    switch   
File Size289KB,10 Pages
ManufacturerAPEM
Environmental Compliance  
Download Datasheet Parametric View All

SY244THCD-6X601U629U4602 Overview

Rocker Switch, DP3T, Latched, 0.02A, 20VDC, Solder Terminal, Rocker Actuator, Through Hole-straight

SY244THCD-6X601U629U4602 Parametric

Parameter NameAttribute value
Is it lead-free?Lead free
Is it Rohs certified?conform to
MakerAPEM
Reach Compliance Codecompliant
ECCN codeEAR99
Actuator typeROCKER
body width11.35 mm
body height11.7 mm
Body length or diameter15.75 mm
Contact (AC) maximum rated R load.02A@20VAC
Maximum contact current (AC)0.02 A
Maximum contact current (DC)0.02 A
Contact (DC) maximum rated R load.02A@20VDC
Maximum contact voltage (AC)20 V
Maximum contact voltage (DC)20 V
Electrical life50000 Cycle(s)
Manufacturer's serial numberS
Installation featuresTHROUGH HOLE-STRAIGHT
Maximum operating temperature85 °C
Minimum operating temperature-20 °C
method of packingBULK
sealEPOXY TERMINAL SEALED
surface mountNO
Switch actionLATCHED
switch functionDP3T
Switch typeROCKER SWITCH
Termination typeSOLDER
S and SR series
Washable rocker and paddle switches
Distinctive features and specifications
Sealed
• Secure assembly of the two case parts
• Internally sealed bushing
• Epoxy sealed terminals
Process compatible (S series)
• Wave solderable
• Washable
Optional ESD protection
ELECTRICAL SPECIFICATIONS
MATERIALS
D
• Max. current/voltage rating with resistive load :
- silver contacts (A or 1) : 2A 250VAC - 5A 125VAC - 4A 30VDC
- brass, gold plated contacts (CD or 0) : 0,4VA 20VAC or DC
- silver, gold plated contacts (AD or 2) : 2A 250VAC - 5A 125VAC - 4A 30VDC
(300mA 30VDC for gold plating)
• Initial contact resistance : 10 mΩ max.
• Insulation resistance : 1.000 MΩ min.
• Dielectric strength : 1.000 Vrms 50 Hz min.
• Electrical life with nominal load :
Contacts
A or 1
CD or 0
AD or 2
Number of cycles
2 positions
40.000
100.000
40.000
3 positions
40.000
50.000
40.000
• Case and cover : UL94-V0,
polyamide, glass filled or PES
• Actuator : polyamide
• Contacts
CD
or
0
: brass, gold plated
A
or
1
: silver
AD
or
2
: silver, gold plated
• Terminal seal : epoxy
GENERAL SPECIFICATIONS
AGENCY APPROVALS
• Mechanical strength :
Terminals are strengthened by a bracket or a ground plate ensuring the
rigidity of the switch on the board. Actuator strength is 10N max.
• Operating temperature : -20°C to +85°C
• Storage temperature : -40°C to +85°C
• Moisture :
The insulating materials employed and the complete seal permit the switches
to withstand a 56 days moisture test (IEC 68-2-3).
• Soldering - thermal shock (S series only) :
The switches are especially designed for flow soldering at 260°C during
5 seconds owing to high temperature polymer parts.
• Iron soldering (SR series) : 300°C 5 sec. max.
• Solderability : The switches are tested at 235°C according to IEC 68-2-20
after accelerated aging.
Availability
: consult factory for
details of approved models.
Marking
: to order switches
marked UL, complete appropriate
box of ordering format.
D-10
www.apem.com
APEM
I would like to ask a question about external memory bus reading and writing
Connect the LCD controller to the 2407DSP in bus connection mode, that is,the LCD 8-bit data line DB7-DB0 is connected to the DSP data line D15-D18 pins,the LCD R/W is connected to the DSP address lin...
che3ccc Analogue and Mixed Signal
Ask about JFlash burning Atmel
Environment: JFlash SWD mode, three-wire SCLK SDIO GND Atmel SAMD10D14AM Problem 1, JFlash can connect to SAMD10, but the burning will probably fail. The error reported is “Can not read register 20 (C...
liudijiang Microchip MCU
New MicroPython Pi calculation performance comparison
Last weekend, I did a new comparison of pi calculations, comparing the performance of different processors by calculating pi with different digits. In addition to MicroPython, I also did a comparison ...
dcexpert MicroPython Open Source section
Reasons for failure in calling KernelIoControl to obtain the logical interrupt number
Please advise: if(!KernelIoControl(IOCTL_HAL_REQUEST_SYSINTR,&g_Irq,sizeof(UINT32),&g_SysIntr,sizeof(UINT32),NULL)) { RETAILMSG(1,TEXT("ERROR:Failed to request sysintr value for Timer1 inturrupt!/r/n"...
小飞龙 Embedded System
Please, administrator, please restore the ability to invite 8 people. I will no longer suggest pressing the Enter key to automatically query.
Please, administrator, please restore the ability to invite 8 people. I will no longer suggest pressing the Enter key to automatically query....
深圳小花 Suggestions & Announcements
Develop the Internet of Things in 10 minutes: Remote formaldehyde monitoring (4G module)
[i=s]This post was last edited by Maoqiu Dada on 2021-12-21 18:31[/i]ShineBlink is a universal IoT smart hardware development board with zero threshold, zero development environment and low code. Gizw...
毛球大大 RF/Wirelessly

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

Robot
development
community

Index Files: 1031  1815  2510  189  1056  21  37  51  4  22 
Datasheet   0 1 2 3 4 5 6 7 8 9 A B C D E F G H I J K L M N O P Q R S T U V W X Y Z
Room 1530, 15th Floor, Building B, No. 18 Zhongguancun Street, Haidian District, Beijing Telephone: (010) 82350740 Postal Code: 100190
Copyright © 2005-2026 EEWORLD.com.cn, Inc. All rights reserved 京ICP证060456号 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号