PW125XA1503

Recently, the U.S. Department of Commerce announced that it would prohibit companies in the country from selling any electronic technology or communication components to ZTE, a Chinese communicatio...[Details]

Regarding the PHY construction of LWIP, the PHY chip used is LAN8720A, RMII mode.  Regarding the hardware connection part, the Atomic board F407 is used, and the hardware connection is as follows:  ...[Details]

    The implementation of CAN driver under embedded operating system Android requires not only adding CAN driver device in Linux kernel, but also implementing the call of Android HAL layer. Taking S5...[Details]

In 2018, the National Development and Reform Commission issued a new photovoltaic subsidy policy. The benchmark on-grid electricity price was significantly reduced, the return on investment decreased,...[Details]

pre name="code" class="cpp" uint32_t ADC_Detect(uint32_t  AD_Channel)   {          hadc.Instance- CHSELR = 0;       ADC_ChannelConfTypeDef sConfig;       sConfig.Channel = AD_Channel;           sConf...[Details]

The storage media corresponding to the three boot modes of STM32 are built-in to the chip, they are:  1. User Flash = Flash built into the chip   2.SRAM = RAM area built into the chip, which is the m...[Details]

Pin Definition  FSMC configuration steps 1. Enable the corresponding pin GPIO clock  2. Configure the GPIO pin mode  3. Enable the FSMC clock  4. FSMC initialization  5. Memory block enable Examp...[Details]

OSC_IN and OSC_OUT are external crystal pins by default. If you do not use an external crystal oscillator on the STM32, how to connect OSC_IN and OSC_OUT If you use the internal RC oscillator instead...[Details]

1. What is PWM      What is PWM? Professionally speaking, it is pulse width modulation. In layman's terms, it is the continuous output of high and low levels. For example, the microcontroller outputs...[Details]

When the program starts running, light A turns on for 5 seconds, then turns off, light B turns on for 5 seconds, light B turns off, light C turns on for 5 seconds, light C turns off, the program ends...[Details]

/*-----------------------------------------------     Name: Two-color dot matrix     Forum: www.doflye.net     Written by: shifang     Modification: None     Content: Using hc595 to drive two-color d...[Details]

Using AT89S51 microcontroller, modify the original one to turn the LED on for 4s and off for 2s. Thank you. Use a timer. (The program is written in the answer, omitted here - just a note) The origi...[Details]

The circuit shown in the figure requires that the light is off when the machine is turned on. Press the button once, and the light D1 will turn on and automatically turn off after a delay of 10 secon...[Details]

AI chips are becoming a new trend in the industry. On November 15, Qualcomm announced that it would invest in nine Chinese AI algorithm + chip innovation companies. Let's follow the network c...[Details]

　　The STC12C5412AD microcontroller is an enhanced 8051 standard 51 series microcontroller. It is 12 times faster than the ordinary 8051 and can be programmed on a home computer without an emulator. 　...[Details]