NM-212-021-161-00AA

Hardware platform: stm32F407Zet6 Software platform: stm32cubeMX 4.7+MDK5.14 Circuit connection: PE8-LED0, PE9-LED1, PE10-LED2, PE11-LED3 Step 1: Create a project using stm32cubeMX 1. Start the soft...[Details]

stm32cubeMX graphical configuration content STM32CubeMX is part of the original STMCube initiative from st microelectronics, and STM32Cube includes STM32CubeMX. STM32CubeMX is a graphical software co...[Details]

Function List and Notes (lower-level driver part) 1. IO port initialization: control IO and communication IO. Control includes power control, reset and low power mode. Communication is the serial po...[Details]

Overview Lightning is a strong discharge phenomenon that occurs between thunderstorm clouds and between thunderstorm clouds and the earth due to severe convective weather. Lightning is gen...[Details]

Artificial intelligence There is no inherent bias in AI. It does not "think" something is true or false for reasons that cannot be explained by logic. Unfortunately, human bias exists in mach...[Details]

I used the bit definition in my 51 program: bit flag. After defining it this way, I ran the program and downloaded it to the circuit board. I found that the flag was not the value I set, which led to...[Details]

The Vatican Secret Archives is one of the world's greatest historical collections, but many of its documents have never been transcribed. Recently, a project called Codice Ratio used a combination...[Details]

Introduction: As a power electronic device, the photovoltaic inverter mainly converts the direct current generated by the photovoltaic module into alternating current. Because there are thousands o...[Details]

Interrupts and timers implement a 24-hour clock. The program is as follows: #include reg52.h   #define PORTLEN P0   sbit bit_select = P2^0; sbit seg_select = P2^1;   unsigned char src = {0x3f,0x06,0...[Details]

T1 or T2 are two timers/counters of MCS-51 microcontroller. The first method can use two timers/counters to generate rectangular waves. In order to save interface resources, the second method is used...[Details]

Requirements: Set timer T1 as an external event counter, count 500 pulses every time, then switch T1 to timing mode and output a positive pulse with a width of 10ms at P1.2. Over and over again. A...[Details]

　　According to a report by Russian News Agency on November 23, Alexander Hanin, founder and general manager of VisionLabs, a Russian facial recognition software development company, believes that in ...[Details]

Not long ago, we discussed the disruptive trends that will change the future of display solutions and the changes that High Dynamic Range (HDR) can bring , which provides a more realistic...[Details]

    This design is intended to take advantage of the above favorable conditions and propose an image acquisition solution based on the TMS320C6x11 series DSP. By taking advantage of the uniformity of...[Details]

5.1. Usage of EM78 series 8-bit microcontroller special instructions 5.1.1. Table Lookup Instructions and Usage The EM78 series 8-bit microcontroller uses three steps to look up the table: (1) "call"...[Details]