A165W-J3AR-T2-2

Recently, the first Digital China Summit was held in Fuzhou, attracting many domestic ICT industry giants to participate in the exhibition. The long queues outside the venue, the noisy and exciting...[Details]

International Solar Photovoltaic Network News: Chinese inverter company Sungrow announced that it will build a 3GW photovoltaic inverter manufacturing plant in Bangalore, the capital of Karnataka, ...[Details]

1. Problem When developing STM32 with IAR, I found that I could not print floating point numbers by redirecting printf to the serial port. The code is as follows:  The output is as follows:  It can...[Details]

After searching a lot of information, I finally understood the time base timer. I did not use any library functions but operated the registers directly. The following introduces the systick in STM32...[Details]

　　Recently, the US embargo on ZTE has attracted much attention. Let's take a look at the relevant content with the automotive electronics editor. 　　On April 16, local time, the U.S. Department of Co...[Details]

What is SYSTICK: This is a 24-bit system tick timer, SysTick, with automatic reload and overflow interrupt functions. All microcontrollers based on the Cortex_M3 processor can obtain a certain time ...[Details]

Independent watchdog (IWDG) and low power mode are often used in STM32 development. The watchdog is to detect and solve faults caused by software errors, and the low power mode is to enter sleep mode...[Details]

The pins of stm32 have two uses: GPIO (general purpose io) and AFIO (alternate function io) For some pins (depending on the chip), neither of these two uses exists. For example, in 64-pin products, O...[Details]

I have encountered many problems when tinkering with LD driver recently. I will record them one by one below. Otherwise, who will remember who in five hundred years? 1. Configuration issues of multi-...[Details]

ADC: 1. The ADC module inside STM32 has three ADC1, ADC2, and ADC3, which are independent of each other, so synchronous sampling can be performed. 2ADC input clock must not exceed 14MHz, it is genera...[Details]

T1 or T2 are two timers/counters of MCS-51 microcontroller. The first method can use two timers/counters to generate rectangular waves. In order to save interface resources, the second method is used...[Details]

(1) JTAG is a communication standard used for real-time and fast communication between computers and microcontrollers. The JTAG function of AVR (only available on some models) makes AVR debugging ver...[Details]

As an important branch of the power electronics industry, the technological progress of photovoltaic inverters is highly dependent on the development of electronic components and control technology...[Details]

While imaging industry experts know that Apple has designed a complex 3D camera for its iPhone X, called "TrueDepth," most of the details of the 3D system inside the module, including chips, componen...[Details]

    Each I/O port of the AVR microcontroller corresponds to three registers: DDRx, PORTx and PINx, where DDRx is the data direction, i.e. input or output; PORTx is the state of the internal pull-up r...[Details]