98852-113TLF

In the past few days, the news that ZTE was "banned" by the US Department of Commerce has triggered widespread reflection and concern in various domestic industries about the lack of independent co...[Details]

I used STM32CubeMX V4.22.1 to generate a project including EHT and Lwip. The debugging has been abnormal. After careful inspection, the following problems were found: 1. The hardware uses LAN8720A, b...[Details]

    The implementation of CAN driver under embedded operating system Android requires not only adding CAN driver device in Linux kernel, but also implementing the call of Android HAL layer. Taking S5...[Details]

1. Heart rate measurement principle 1. What is a heart rate module? The heart rate module is professionally used to monitor the heart rate of the wrist, fingers, forehead, earlobe, chest and other ...[Details]

pre name="code" class="cpp" uint32_t ADC_Detect(uint32_t  AD_Channel)   {          hadc.Instance- CHSELR = 0;       ADC_ChannelConfTypeDef sConfig;       sConfig.Channel = AD_Channel;           sConf...[Details]

Pin Definition  FSMC configuration steps 1. Enable the corresponding pin GPIO clock  2. Configure the GPIO pin mode  3. Enable the FSMC clock  4. FSMC initialization  5. Memory block enable Examp...[Details]

Proteus simulation circuit diagram C language program #include  absacc.h    #include  reg52.h       #define DA0832 XBYTE       #define uchar unsigned char   #define uint unsigned int     ...[Details]

Program ideas and defects reference: 51 single chip microcomputer (AT89C52) matrix keyboard detection program #include iom16v.h   typedef unsigned char uchar;   typedef unsigned int uint;   #define ...[Details]

The single-chip microcomputer running light program requires all 32 serial ports to be used, and each serial port has eight LEDs.  Question supplement: The 8051 single-chip microcomputer is used, an...[Details]

A simple experimental programming question for the microcontroller: write a 3-byte binary addition subroutine. The program entry is: addend 1: 22H, 21H, 20H three bytes, 22H is the highest bit; adden...[Details]

Using AT89S51 microcontroller, modify the original one to turn the LED on for 4s and off for 2s. Thank you. Use a timer. (The program is written in the answer, omitted here - just a note) The origi...[Details]

1. Pin: 0 in 1 out  Set Status  Output status IO register setting          DDR×A certain bit is set to 1, and the corresponding bit IO is set to output;          PORT×A certain position is 1/0, and t...[Details]

#include avr/io.h #include avr/interrupt.h int main() { DDRB|=0X20;//Set PWM waveform output, connected to port PB5, see the comment of OCR1A=15625 for details DDRE=0X04; PORTE=0X04; DDRA=0XFF; P...[Details]

　　 After three years of continuous decline in its mobile phone business, ZTE has finally revealed its true feelings to the outside world: the Chinese market is its weak point, and it is planning to f...[Details]

MSP430 MCU Stepper Motor Program #include "msp430x22x4.h"  #define uchar unsigned char  #define uint unsigned int  uchar i=0;  // Scanning 4x4 keyboard #define keyin (P2IN&0x0F)  //digital tube v...[Details]