Production specification
Transient Voltage Suppressor
Features
Low incremental surge resistance,
excellent clamping capability
Low profile package with built-in strain relief
for surface mounted applications
Typical ID less than 1.0μA above 10V
waveform, repetition rate (duty cycle): 0.01%
Very fast response time
High temperature soldering guaranteed:
260°C/10 seconds at terminals
3.0SMCJ5.0--3.0SMCJ440CA
Mechanical Data
Case: SMC molded plastic
Molding compound, UL flammability classification rating 94V-0
Terminals: Solder plated, solderable per MIL- STD-202,Method 208
Polarity: Color band denotes cathode end
For bi-directional devices, use suffix C or CA (e.g. SMCJ10C, SMCJ10CA). Electrical
characteristics apply in both directions.
Devices for Bidirectional Applications
Maximum Ratings
(@T
A
= 25°C unless otherwise specified)
Parameter
Peak Pulse Power Dissipation on 10/1000uμ waveform
(Notes 1,2, Fig.1)
Peak Pulse Current on 10/1000μs waveform(Note 1)Fig.3
Peak Forward Surge Current 8.3ms single half sine-wave
superimposed on rated load (JEDEC Method) (Notes 2,3)
Operating junction and storage temperature range
Symbol
P
PPM
I
PPM
I
FSM
T
J
, T
STG
Value
3000
See Table Below
200
-55---+150
Units
W
A
A
℃
NOTES:
1. Non-repetitive current pulse, per Fig. 3 and derated above T
A
=25°Cper Fig. 2.
2. Mounted on 8.0mm2 ( .013mm thick) land areas.
3. Measured on 8.3ms , single half sine-wave or equivalent square wave ,
duty cycle= 4 pulses per minutes maximum.
TVP0051A
www.gmesemi.com
51mcu
京公网安备 11010802033920号
EEWORLD
