TMM-126-06-H-S-SM-23-P

China's photovoltaic power generation installed capacity achieved rapid growth in 2017, and distributed photovoltaics achieved explosive growth. In 2017, the country's photovoltaic installed capaci...[Details]

In our common sense, the word technology often has two definitions. The first is the technology sealed in the laboratory. They are like flowers on the mountain top. Only a few people on the mountai...[Details]

1. Placement suspension void NVIC_Configuration(void) {   NVIC_InitTypeDef NVIC_InitStructure;   /* Set the Vector Table base location at 0x08004000    NVIC_SetVectorTable(NVIC_VectTab_FLASH, 0x4000)...[Details]

1. Function prototype In the function library officially provided by STM32, you can find functions like HAL_Delay(). This function uses a timer to achieve a more accurate time delay and provides it...[Details]

Regarding the PHY construction of LWIP, the PHY chip used is LAN8720A, RMII mode.  Regarding the hardware connection part, the Atomic board F407 is used, and the hardware connection is as follows:  ...[Details]

Remarks: Focus on IoT application development and share IoT technology experience. Software platform: IAR6.5 TCP/IP protocol stack: LWIP1.4.1 Hardware platform: STM32F103C8T6 wired communication ...[Details]

Function List and Notes (lower-level driver part) 1. IO port initialization: control IO and communication IO. Control includes power control, reset and low power mode. Communication is the serial po...[Details]

introduction In the general project development process, two or more microcontrollers are often required to communicate to complete data transmission. For example, a quadcopter wirelessly transmits d...[Details]

Security PPP is a new model of urban video surveillance projects: 1) The government and social capital establish a project company in a certain proportion; 2) The project company participates in the ...[Details]

Processors with artificial intelligence are mostly integrated into cars, PCs, security cameras, smart speakers, robots and other related technology equipment, but AI chips were initially de...[Details]

When STM32 uses JTMS (PA13) and JTCK (PA14) as normal I/O ports, add the following code before initialization (the order cannot be reversed):   RCC_APB2PeriphClockCmd(RCC_APB2Periph_AFIO, ENABLE); G...[Details]

OSC_IN and OSC_OUT are external crystal pins by default. If you do not use an external crystal oscillator on the STM32, how to connect OSC_IN and OSC_OUT If you use the internal RC oscillator instead...[Details]

The first one is a DMA mode of multiple channel acquisition void ADC_DMA_Config(void)  { ADC_InitTypeDef ADC_InitStructure; RCC_HSICmd(ENABLE); while (RCC_GetFlagStatus(RCC_FLAG_HSIRDY) == RESET);  ...[Details]

1. Common knowledge about DMA.  1. Function: to achieve high-speed data transmission between chips. That is, it can achieve data transmission without occupying the CPU.  2. Mode: There are three tran...[Details]

DMA： 1. When using DAC, when the converted analog signal is output through the IO port, why is the IO port also configured to input mode? PS: The stm32 manual defines that PA4 and PA5 are connected...[Details]