EEWORLDEEWORLDEEWORLD

Part Number

Search

DTA-060A

Description
To 60 Watts Single Output AC/DC Desktop Power Supply
File Size48KB,2 Pages
ManufacturerWall Industries,Inc.
Websitehttps://www.wallindustries.com/
Download Datasheet View All

DTA-060A Overview

To 60 Watts Single Output AC/DC Desktop Power Supply

Rev B
DTA-060A Series
To 60 Watts
Single Output
AC/DC Desktop Power Supply
FEATURES
Single Output
High Reliability
Input: 90~264VAC
100% Hi-Pot Tested
100% Burn-In Tested
Total Power: 40~60 Watts
AC Input: IEC-320-C14 Inlet
Safety Approvals, EMC Compliance
Dimensions: 5.20 x 2.72 x 1.57 Inches
Over Voltage, Over Load, and Short Circuit Protected
DESCRIPTION
The DTA-060A series offers up to 60 Watts of power in a single output universal input AC/DC desktop power supply. Output
voltages are available from 9VDC to 24VDC. This series also has an IEC-320-C14 AC inlet connector and has over voltage,
over load, and short circuit protection. All units are 100% burn-in and hi-pot tested and have safety approvals and EMC
compliance.
SPECIFICATIONS:
DTA-060A Series
All specifications apply @ ±25°C ambient unless otherwise noted
INPUT SPECIFICATIONS
Input Voltage Range ............................. 90 ~ 264 VAC (full range)
Input Frequency ............................................................. 47 - 63Hz
Input Current (rms)................. 2A @ 90VAC; 1A @ 264VAC max.
ENVIRONMENTAL SPECIFICATIONS
Operating Temperature ............................................. 0°C to +40°C
Storage Temperature............................................... -10°C to+70°C
Humidity........................................................................20% ~ 90%
MTBF ................ >80,000 hrs at FL and 25°C ambient temperature
OUTPUT SPECIFICATIONS
Output Current ................................................................ see table
Output Voltage ................................................................ see table
Output Regulation ................................................................ 3~5%
Maximum Power ............................................................. see table
PHYSICAL SPECIFICATIONS
Weight ....................................................................................12 oz
Dimensions (L x W x H) ...........................5.20 x 2.72 x 1.57 inches
132 x 69 x 40 mm
AC Inlet ...................................................................... IEC-320-C14
Ripple/Noise (20 MHz BW) ...................................................... 1%
Hold Up Time .................... >10ms typical at full load and 115VAC
SAFETY & EMI
Safety Standards ...........................................................UL60950-1
...................................................................CSA C22.2-No.60950-1
.............................................................................. TUV EN60950-1
.............................................................................. CB IEC 60950-1
EMI Standards ............................................................FCC Class B
............................................................................ CISPR22 Class B
........................................................................... EN 55022 Class B
................................................................................................... CE
PROTECTION
Short Circuit Protection ........................................... Auto-recovery
Over Load Protection .............................................. Auto-recovery
Over Voltage Protection .......................................... Auto-recovery
GENERAL SPECIFICATIONS
Efficiency....................................... >75% @ full load and 115VAC
Due to advances in technology, specifications subject to change without notice
Wall Industries, Inc. 5 Watson Brook Road Exeter, NH 03833
603-778-2300 www.wallindustries.com Fax 603-778-9797
Conflict between stm32 RTC and RC522
The system uses RTC second interrupt for timing, and at a certain moment, it needs to read the card through RC522During the operation, I put the mf card close to the card reader and found that I could...
cyhssw12 stm32/stm8
High score send: About the definition of FLASH_BASE_ADRS when establishing TFFS (mpc8379 development board)
The situation is that there are two flashes on the board, one 32Mnor and one 256Mnand. The nor flash driver is already ready. When making nand flash driver, mtd layer is written, and a FLASH_NAND_BASE...
painache Embedded System
Wireless communication program implemented with MSP430F5529 and CC2500 wireless modules
Does anyone have a wireless communication program implemented using MSP430F5529 and CC2500 wireless modules (the more closely related 430 model is also OK), as long as it implements simple communicati...
六度分离xia Microcontroller MCU
Aunt Liu in the Harem (1905)
Regarding square dancing, I have always wondered, what is the point of practicing it when there is so much pollution? It is not all about the exercise itself, which should make sense. The video may be...
wangfuchong Talking
What is the difference between metallization and non-metallization of mechanical holes in PCB board manufacturing?
As the title says, in PCB manufacturing, some boards use non-metallized holes, while others use metallized holes, which are connected to the ground of the circuit. What is the use of this? If the grou...
lovemail PCB Design

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

Robot
development
community

Index Files: 2581  2141  2638  1159  2632  52  44  54  24  53 
Datasheet   0 1 2 3 4 5 6 7 8 9 A B C D E F G H I J K L M N O P Q R S T U V W X Y Z
Room 1530, 15th Floor, Building B, No. 18 Zhongguancun Street, Haidian District, Beijing Telephone: (010) 82350740 Postal Code: 100190
Copyright © 2005-2026 EEWORLD.com.cn, Inc. All rights reserved 京ICP证060456号 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号