The four-digit digital tube display program I wrote runs correctly at full speed, but it fails when I single-step. The digital tube flickers and single-stepping has no effect at all. I would like some...
I use Raspberry Pi to connect to Zigbee Coordinator serial port, and Zigbee Coordinator forms a subnet with 7 nodes. Raspberry Pi periodically sends heartbeats to Coordinator through the serial port, ...
Hello everyone, I recently used CCS to debug the 8168 bare board, and there were some inexplicable problems. The code is as follows: #define I2C0_BASE 0x48028000 #define I2C0_CON *( Uint32* )( I2C0_BA...
On April 19, it was reported that Alibaba DAMO Academy is developing a neural network chip, Ali-
NPU
, which is mainly used for
AI
reasoning calculations such as image and video analys...[Details]
China Energy Storage Network News:
On April 24, State Grid Corporation of China (hereinafter referred to as "SGCC") and China Southern Power Grid Co., Ltd. (hereinafter referred to as "CSGC")...[Details]
When
artificial intelligence
can help humans take on some work, we always divide the responsibilities of both parties very clearly. When humans work, we rarely see
artificial intelligen...[Details]
1. Principle 1. Infrared emission protocol The infrared transmission protocol has been written in the previous article , so I will not repeat it here. 2. Timer counting and input capture A timer...[Details]
In the actual project development process, hardware circuits often need to be modified, and the modified parts need to modify the driver. Thinking about the coming and going of such requirements is t...[Details]
The program got stuck during LCD initialization. Through hardware debugging, it was found that it was stuck in the Delay_ms() function. Going to the definition, it was found to be a macro definition ...[Details]
This is also a routine in the development board, with explanations of the key points. The program is as follows: /********************************************************* Program notes: First...[Details]
STM32 has two watchdogs: independent watchdog and window watchdog. This article mainly introduces the use of independent watchdog. Independent watchdog (IDWG): driven by an independent 40KHZ low-sp...[Details]
When STM32 uses JTMS (PA13) and JTCK (PA14) as normal I/O ports, add the following code before initialization (the order cannot be reversed): RCC_APB2PeriphClockCmd(RCC_APB2Periph_AFIO, ENABLE); G...[Details]
This example sets up a button to adjust the square wave of different frequencies (multiples of 100) from 100-1000hz. In addition, serial port communication is added, and the corresponding frequency c...[Details]
Design a program for the 51 single-chip microcomputer. It is known that the crystal oscillator frequency of the 89C51 single-chip microcomputer is 12MHz, and it is required to use T1 timing to output...[Details]
Circuit: Using AT89S52 single chip microcomputer. P3.0 to P3.3 are connected to four external buttons. P3.4 to P3.7 are the bit selection ports for controlling the four digital tubes, and P1 is the s...[Details]
It is required to use MCS-51 microcontroller to sort data. 1. Sort the 8 data in ascending order; 2. The data to be sorted is stored in the internal data memory address units 30H-37H, which are 34H, ...[Details]
International Solar Photovoltaic Network News: On November 21, Australia's SMA Solar Technology Co., Ltd. signed a contract with the local government to provide photovoltaic inverters with an insta...[Details]
:For medium and large-scale domestic photovoltaic power stations, inverters generally go through an open bidding process. Due to the high technical content of power station design, it is necessary ...[Details]
DSP and ARM Processors
京公网安备 11010802033920号
EEWORLD
