The 53501 Series Solid State Power Controllers are light -weight devices resistant to damage from shock and vibration, and
immune to contact-related problems (contamination, arcing) associated with mechanical equivalents.
Transformer coupling bet ween the input and output stages provides effective isolation up to 1000 V RMS. The Power FET
output eliminates bipolar offset and minimizes output voltage drop.
The preferred control input is CMOS enabling a fully functional Status Output. The input operates from a bias supply of 4.5 to
5.5VDC (See Figure 1).
Integral short-circuit protection, I
2
T trip and status output is provided. These units sense excessive current flow while under
2
load or while switching, and respond with an I T trip curve opening the output. An open-collector status is available to
indicate that the short circuit protection has been activated. The output will remain blocked indefinitely until the short is
removed and the unit reset. This feature prevents damage to the controller and also averts further system failures that may
be caused by the short circuit. Status line output remains on until the relay is turned off for resetting. Resetting the unit can
be accomplished by recycling the input control.
The devices are available in a variety of quality levels from COTS to class K including any custom screening requirements.
ABSOLUTE MAXIMUM RATINGS
1
Isolation voltage ............................................................................................................................. 1000 V RMS
2
Continuous operating output voltage ................................................................................ 100, 200, 400 or 500 VDC
Load Current:.................................................................... Less Than 8 Times Rated Operating current / Self Limiting
Bias supply voltage, V
DD
................................................................................................................. 4.5 to 5.5 VDC
Operating temperature .........................................................................................................-55ºC to +125ºC Case
Storage temperature ....................................................................................................................-55ºC to +125ºC
Notes:
1
2
60 Hz sine wave
Reversing polarity on the out put may cause permanent damage
Micropac Industries
cannot assume any responsibility for any circuits shown or represent that they are free from patent infringement.
Micropac
reserves the right to make changes at any time in order to improve design and to supply the best product possible.
MICROPAC INDUSTRIES, INC. MICROCIRCUITS PRODUCTS DIVISION
•
905 E. Walnut St., Garland, TX 75040
•
(972) 272-3571
•
Fax (972) 494-2281
•
•
•
www.micropac.com
E-MAIL:
microsales@micropac.com
1/17/05 Rev E
Pg. 1 of 7
53501 Series
ELECTRICAL CHARACTERISTICS
T
A
= +25° C
PARAMETER
Input characteristics
CMOS configurations (Figure 1)
Bias supply range, V
DD
Bias current
Input current
Control voltage range
Turn-off voltage
Turn-on voltage
Dielectric strength
Output characteristics
Output current, sustaining:
Continuous blocking voltage
On-state resistance, R
ds
Turn-on time @ 25ºC case
Turn-off time @ 25ºC case
Off-state leakage
Output Capacitance
Load Start current
Short-circuit peak
Trip Reset Time
Status Output Specification
Status Supply Voltage (open Collector)
Status off leakage current
Status off leakage current
Status on voltage
High-To-Low Transition Time
Junction temperature
Thermal resistance,
θ
JA
θ
J C
SPST SOLID-STATE POWER CONTROLLERS
TEST CONDITIONS
MIN
TYP
MAX
UNITS
4.5
10
5 VDC Input
-0.5
2.8
0.5
60 Hz
Steady state load
25ºC Case
1000
1.0 / 2.0
2.0
5.5
20
250
5.5
3.2
VDC
mA
µ
A
VDC
VDC
VDC
V RMS
2.0 / 4.0
400
See Table 1
0.4
0.1
.8
1.0
100
700
9/18
100
A
VDC
Ohms
mS
mS
µ
A
At Maximum Blocking Voltage
25ºC
Shorted while on at 25ºC
See Figure 2 Note 3
Remove short / overload
& Cycle input
6/12
40
7.5/15
pF
A
A
mS
50
5.0
32
100
4
0.4
20
50
150
30
5
VDC
µADC
µADC
VDC
µS
ºC
ºC/W
ºC/W
VS = 30 VDC
VS = 15 VDC
I
STATUS
= 5 MA
I
STATUS
= 5 MA
APPLICATION NOTES:
1. Maximum input switching frequency not to exceed 10 Hz under normal conditions, or 1 Hz if output is shorted.
2. Inductive loads must be suppressed.
3. Peak current that may flow when out put is shorted.
Table 1
R
DS
On @ 25°C
100V
200V
400V
500V
.2
.3
.4
.5
Micropac Industries
cannot assume any responsibility for any circuits shown or represent that they are free from patent infringement.
Micropac
reserves the right to make changes at any time in order to improve design and to supply the best product possible.
MICROPAC INDUSTRIES, INC. MICROCIRCUITS PRODUCTS DIVISION
•
905 E. Walnut St., Garland, TX 75040
•
(972) 272-3571
•
Fax (972) 494-2281
•
•
•
www.micropac.com
E-MAIL:
microsales@micropac.com
1/17/05 Rev E
Pg. 2 of 7
53501 Series
V
DD
22
SPST SOLID-STATE POWER CONTROLLERS
STATU
S
16 12
LOAD
V
LOAD
CMOS
1
I
250
ìA SOURCE
3
9
Figure 1 – CMOS Input Configuration
V
DD
CONTROL
GROUND
STATUS
22
1
9 3
12
V
LOAD
16
R
L
SHORT
SIMULATION
Figure 2 - Block Diagram (High Side Switch)
1 ms
CONTROL
MAX
10 & 90%
1 ms
t
ON
LOAD VOLTAGE
10%
MAX
90%
10%
t
OFF
Figure 3 - SWITCHING CHARACTERISTICS
4-
Micropac Industries
cannot assume any responsibility for any circuits shown or represent that they are free from patent infringement.
Micropac
reserves the right to make changes at any time in order to improve design and to supply the best product possible.
MICROPAC INDUSTRIES, INC. MICROCIRCUITS PRODUCTS DIVISION
•
905 E. Walnut St., Garland, TX 75040
•
(972) 272-3571
•
Fax (972) 494-2281
•
•
•
www.micropac.com
E-MAIL:
microsales@micropac.com
1/17/05 Rev E
Pg. 3 of 7
53501 Series
SPST SOLID-STATE POWER CONTROLLERS
CONTROL
ON
OFF
ON
SIMULATED
SHORT
OFF
3A
I
OUT
STATUS
OFF
ON
Figure 5 - TIMING DIAGRAM
NOTE:
1) A turn-on into a short produces an increase in current to the initial I
2
T must trip value.
2) Shorted while On from any On operating condition can have a several
µs
surge current of as much as 100A .
Micropac Industries
cannot assume any responsibility for any circuits shown or represent that they are free from patent infringement.
Micropac
reserves the right to make changes at any time in order to improve design and to supply the best product possible.
MICROPAC INDUSTRIES, INC. MICROCIRCUITS PRODUCTS DIVISION
•
905 E. Walnut St., Garland, TX 75040
•
(972) 272-3571
•
Fax (972) 494-2281
•
•
•
www.micropac.com
E-MAIL:
microsales@micropac.com
1/17/05 Rev E
Pg. 4 of 7
53501 Series
SPST SOLID-STATE POWER CONTROLLERS
Package Dimensions
2.100
1.750
1.450
.735
Ø.157
2 PLACES
.795
(1.390)
.240 MAX.
(.060)
.45 MIN.
Ø.040, 6 PLACES
1
3
9
.400
.200
22
16
12
.200
.600
.800
1.000
(BOTTOM VIEW)
TOL: ±.010
IN
1
3
9
12
16
22
FUNCTION
Control
GND
-OUT
+OUT
Status
V
DD
Micropac Industries
cannot assume any responsibility for any circuits shown or represent that they are free from patent infringement.
Micropac
reserves the right to make changes at any time in order to improve design and to supply the best product possible.
MICROPAC INDUSTRIES, INC. MICROCIRCUITS PRODUCTS DIVISION
I developed a thermostat, and I chose PCF8563 and 24C02. However, for some models of 24C02, the system can work properly. For some models of 24C02, the system cannot work properly, and the time jumps ...
About Yuanchuangda TechnologyHeadquartered in Suzhou Industrial Park, the company specializes in the RD and production of various RF power devices with LDMOS and GaN as the core and GaAs/VDMOS as the ...
[hide]1. Strictly inspect the LED raw materials of the crystal bonding station 1. Crystal: mainly manifested as pad contamination, crystal damage, different crystal cutting sizes, and tilted crystal c...
I want to test the performance of a system I made, using pxa270, which has 256kb internal SRAM. I want to put some heavy computing task function A code into this internal SRAM to run. My current metho...
[size=3][font=微软雅黑]Thank you for participating in [url=https://bbs.eeworld.com.cn/forum.php?mod=viewthread&tid=523163&fromuid=476285]DIY together - wireless portable soldering iron[/url], how is your ...
Source: Electronics World
Noise pollution, gas pollution and solid matter pollution have been called the three major pollutions in the world today. Excessive noise can damage people's health, such as...
Hardware designers have begun to adopt FPGA technology in high-performance DSP designs because it can provide 10-100 times faster computing than PC-based or microcontroller-based solutions. Previou...[Details]
The Mobile Industry Processor Interface (MIPI) Alliance is an organization responsible for promoting the standardization of software and hardware in mobile devices. It has released the D-PHY specif...[Details]
I. Introduction
In the field of power conversion, isolated converters (forward, flyback, and double-ended) with low output DC voltage all use MOSFET as the rectifier device. Since these devi...[Details]
0 Introduction
With the development of society, people pay more and more attention to security work. Monitoring products have been used in various fields instead of being used only in importan...[Details]
1 Introduction
Ultrasonic waves have strong directivity, slow energy consumption, and can propagate over long distances in a medium, so they are used for distance measurement. Ultrasonic detec...[Details]
On the afternoon of July 10, Beijing time, Taiwan's largest chip designer MediaTek expects its smartphone chip shipments to grow by double digits in the third quarter of this year, and the company is ...[Details]
The TPS92210 is a single-stage LED lighting pulse width modulation (PWM) controller. The TRIAC dimmable solution not only regulates the LED current, but also achieves a power factor close to 1. The...[Details]
Car lights, whether headlights, fog lights or tail lights, play an important role in driving safety. However, the material of the car lights determines that the probability of damage in a collision...[Details]
1 Introduction to the overall system solution
The hardware part is mainly used to amplify the sound. When the sound is loud enough, the signal can be introduced into the microcontroller for de...[Details]
1 Introduction
At present, advocating health has become the focus of people's attention, and the emergence of treadmills has become more and more popular. People can exercise at home or in the ...[Details]
Current
measurement:
Magnetic balance Hall current
sensor
is used
. The sensor can measure AC from DC to 100kHz.
In automatic measurement and control systems, it is often nec...[Details]
Synchronous buck designs are becoming increasingly difficult, and the selection of suitable ICs is becoming quite narrow. This Design Idea combines a current-mode PWM IC used in a flyback regulator...[Details]
Some people think: as long as the program runs well, it doesn't matter how the original program is written. But this is absolutely not the case. Software is not completed in one go, and it is neces...[Details]
Introduction
Temperature and humidity control are widely used in people's production and life. People use thermometers and hygrometers to collect temperature and humidity, and control temperatu...[Details]
Embedded System
京公网安备 11010802033920号
EEWORLD
