Last week, I posted a thread to solicit opinions, and everyone gave a lot of good suggestions. However, many opinions are from a general direction, and few are specific, so I hope everyone can give so...
Connect the LCD controller to the 2407DSP in bus connection mode, that is,the LCD 8-bit data line DB7-DB0 is connected to the DSP data line D15-D18 pins,the LCD R/W is connected to the DSP address lin...
Environment: JFlash SWD mode, three-wire SCLK SDIO GND Atmel SAMD10D14AM Problem 1, JFlash can connect to SAMD10, but the burning will probably fail. The error reported is “Can not read register 20 (C...
Last weekend, I did a new comparison of pi calculations, comparing the performance of different processors by calculating pi with different digits. In addition to MicroPython, I also did a comparison ...
Please advise: if(!KernelIoControl(IOCTL_HAL_REQUEST_SYSINTR,&g_Irq,sizeof(UINT32),&g_SysIntr,sizeof(UINT32),NULL)) { RETAILMSG(1,TEXT("ERROR:Failed to request sysintr value for Timer1 inturrupt!/r/n"...
At present, the development of wireless power supply technology for electric vehicles (EVs) is becoming more and more active. In 2012, Volvo of Sweden established Volvo Technology Japan in Tokyo as...[Details]
Microchip's PIC18F46J50 is a low-power, high-performance 8-bit USB microcontroller (MCU) using nanoWatt XLP technology. The current in deep sleep mode can be as low as 13nA, the operating voltage i...[Details]
Automotive applications are particularly sensitive to EMI events, which are unavoidable in a noisy electrical environment consisting of a central battery, bundled wiring harnesses, various inductiv...[Details]
All electronic design engineers and scientists have performed electrical signal analysis, or signal analysis for short. Through this basic measurement, they can gain insight into signal details and...[Details]
In order to highlight the concept of "energy saving and environmental protection" of intelligent buildings, solar street lights are designed for intelligent communities. The inclination and capacit...[Details]
Two simple circuits are implemented to drive two LEDs from a battery powered microprocessor.
This design is based on a circuit that uses three resistors and a microprocessor I/O pin as an input h...[Details]
Although it is relatively easy to check the stability of a simple amplifier at lower frequencies, it may be much more difficult to evaluate the stability of a more complex circuit. This artic...[Details]
1. Introduction
At present, most lighting equipment still uses traditional energy for lighting. Making full use of solar energy as the energy supply for lighting equipment is of great si...[Details]
Microcalorimetry
is used to determine energy relationships. Microcalorimetry techniques are often required when performing calorimetric experiments with small sample sizes or slow heating rat...[Details]
Overview:
This paper introduces a method of connecting a CAN-bus network with Ethernet to form a medium-sized remote monitoring/data transmission network.
CAN (Controller Area Network) is ...[Details]
Many battery-powered systems require a visual indicator to show when the battery needs to be replaced. LEDs are commonly used for this purpose, but they consume at least 10mA of current. This con...[Details]
In recent years, with the rapid development of the information industry, dot matrix LED display screens have been widely used in various advertising and information display systems such as the fina...[Details]
Today, the value of electronic components in cars accounts for 15-20% of the total vehicle. In the future, this proportion may be as high as 30-40% as more safety electronics, fuel consumption and ...[Details]
1. Proposal of
reconfigurable
measurement and control system
The measurement and control system generally refers to a system based on
computers
to realize data acquisition a...[Details]
Traditional
virtual instruments
consist of a data acquisition
board
based on PCI bus and
corresponding software. However, with
the rapid development of
computer
network techno...[Details]