EEWORLDEEWORLDEEWORLD

Part Number

Search

OC-160-CLD-508DA-10.0MHZ

Description
Sine Output Oscillator, 10MHz Nom,
CategoryPassive components    oscillator   
File Size63KB,2 Pages
ManufacturerMicrosemi
Websitehttps://www.microsemi.com
Download Datasheet Parametric View All

OC-160-CLD-508DA-10.0MHZ Overview

Sine Output Oscillator, 10MHz Nom,

OC-160-CLD-508DA-10.0MHZ Parametric

Parameter NameAttribute value
MakerMicrosemi
Reach Compliance Codecompli
Ageing0.1 PPM/YEAR
Frequency Adjustment - MechanicalNO
frequency stability0.05%
Frequency Stability - Voltage0.0005 ppm
input power2.5 W
Installation featuresTHROUGH HOLE MOUNT
offset frequency1 kHz
Nominal operating frequency10 MHz
Maximum operating temperature70 °C
Minimum operating temperature-20 °C
Oscillator typeSINE
Output impedance50 Ω
Output level1 V
Oven power supply voltage5V
phase noise-145 dBc/Hz
physical size36.07mm x 27.18mm x 19.3mm
Nominal supply voltage5 V
surface mountNO
Preheating power6 W
Maximum warm-up time4 Minute
Oven Controlled Crystal Oscillators (OCXO’s)
OC-160 Series (CO-730C)
Description:
The OC-160 Series offers low aging and excellent stability
options with quick warm-up performance with a standard
European CO-08 footprint.
Features:
Frequencies: 5, 10, 12.8, 13, 16.384, 19.44, 20, 20.48 MHz
European CO-08 Package
Excellent Temperature Stability
Superior Aging Characteristics
Very Fast Warm-up
Performance Characteristics
Parameter
Standard
Frequencies:
Package Size:
Supply Voltage:
Input Power:
Output Type:
Output Level (HCMOS):
Rise/Fall Time tr/tf (HCMOS):
Symmetry (Duty/Cycle,HCMOS):
Harmonics/subs:
Spurious:
Temperature Stability:
Characteristics
5, 10, 12.8, 13, 16.384, 19.44, 20, 20.48 MHz, Available 1 MHz to 80 MHz
35.3 x 26.9 x 19.4 mm (1.4” x 1.06” x 0.76”)
A:
15 Vdc ±5%
B:
12 Vdc ±5%
C:
5 Vdc ±5%
<6W turn-on (-20
o
C/70°C);
A:
HCMOS
<2.5W steady-state @ +25°C (-20°C/70°C)
K:
Sinewave ( >+10 dBm into 50 ohm)
Aging:
Short Term Stability (Allan Deviation):
Phase Noise (Typical @ 10 MHz):
Frequency vs. Supply:
Warm-up (Restabilization):
(Frequency relative to two hours after
turn-on following 24 hours off time
at +25
o
C with a maximum ambient
of <70
o
C)
Electrical Frequency Adjust:
Mechanical Configuration:
J:
Sinewave ( >+7 dBm into 50 ohm)
L:
Sinewave ( >+13 dBm into 50 ohm)
“0” <0. 5V, “1” >4.5V
(HCMOS)
<10 ns (10% - 90%)
(HCMOS)
50/50 ±10% (@50% level)
(HCMOS)
-20 dBc (reduced level sinewave, for optional output)
-70 dBc (for sinewave output)
B-308:
±3 x 10
-8 over
0/50°C
B-109:
±1 x 10
-9 over
0/50°C
D-508:
±5 x 10
-8 over
-20/70°C
D-509:
±5 x 10
-9 over
-20/70°C
Note: Tighter stability options
F-107:
±1 x 10
-7 over
-40/85°C
are available, contact factory.
F-108:
±1 x 10
-8 over
-40/85°C
A:
1 x 10
-8
/day, 2x10
-6
/year
B:
3 x 10
-9
/day, 1x10
-6
/year
C:
1 x 10
-9
/day, 3x10
-7
/year
D:
5 x 10
-10
/day, 1x10
-7
/year
5 x 10
-11
/second (with aging
A
or
B);
5 x 10
-12
/second (with aging
C
or
D)
With Aging:
A or B
Aging: C or D
10 Hz
-100 dBc/Hz
-120 dBc/Hz
100 Hz
-135 dBc/Hz
-140 dBc/Hz
1 kHz
-145 dBc/Hz
-145 dBc/Hz
10 kHz
-150 dBc/Hz
-150 dBc/Hz
50 kHz
-150 dBc/Hz
-150 dBc/Hz
2 x 10-9 per % change in supply (with Aging
A
or
B)
5 x 10-10 per % change in supply (with Aging
C
or
D)
With Aging:
A or B
Aging: C or D
-6
: 6 minutes 1 x 10
-6
: 2 minutes
1 x 10
1 x 10
-7
: 8 minutes 1 x 10
-7
: 2.5 minutes
3 x 10
-8
: 10 minutes 3 x 10
-8
: 3 minutes
3 x 10
-8
: 30 minutes 1 x 10
-8
: 4 minutes
10 x 10-6 typical range (with Aging
A or B)
2 x 10-6 typical range (with Aging
C
or
D)
Pins for PCB mounting
Vectron International • 267 Lowell Road, Hudson, NH 03051 • Tel: 1-88-VECTRON-1 • Web: www.vectron.com
46
Good resources of the week (power supply category) the fourth week of February
:) [font=新宋体][size=2][color=#0000ff]↓[/color][color=#00ff]↓[/color][color=#0000ff]↓[/color][color=#00ff]↓[/color][color=#0000ff]↓[/color][color=#0000ff]↓[/color][/size][color=rgb(255, 0, 0)][size=3]Po...
okhxyyo Power technology
Newbie seeking advice
I am looking for a carbon monoxide detection program based on the AT89S52 microcontroller. It requires the use of 1602 to display the concentration information and send the data to the host computer t...
yidaidamaqiao 51mcu
A design of reflective memory card system based on PCI bus
[align=left]1 Introduction For real-time transmission, the traditional Ethernet network is difficult to meet the requirements of real-time network due to the uncertainty of transmission protocol overh...
trueleven Industrial Control Electronics
Problems with stm32 can networking!!! ...
When the stm32 can bus communicates with multiple nodes, one node suddenly loses power, causing the entire can network to be unable to communicate normally. Even after power is restored, the master no...
qirick stm32/stm8
In the MOS tube switch circuit, there is a resistor and a diode in parallel on the gate. What is this used for?
As shown in the figure, I saw these usages in some datasheets. After looking up the information myself, there is a saying that it speeds up the MOS tube segment. I would like to ask the seniors to hel...
lllxxq141592654 Analog electronics
ELF file format analysis
[p=30, 2, left]Embedded operating systems have a wide range of applications and complex and diverse hardware environments. Reducing development costs, shortening development cycles, and improving prod...
rain_noise Download Centre

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

Robot
development
community

Index Files: 1693  1095  2819  314  2175  35  23  57  7  44 
Datasheet   0 1 2 3 4 5 6 7 8 9 A B C D E F G H I J K L M N O P Q R S T U V W X Y Z
Room 1530, 15th Floor, Building B, No. 18 Zhongguancun Street, Haidian District, Beijing Telephone: (010) 82350740 Postal Code: 100190
Copyright © 2005-2026 EEWORLD.com.cn, Inc. All rights reserved 京ICP证060456号 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号