Note: Inclusive of initial frequency accuracy, operating temperature range, supply variation, load variation, 3 times solder reflow, shock, vibration and 1 year aging at 25°C. We do not
recommend hand soldering the devices
REVISION B 12/15/14
3
IDT XO LVDS CRYSTAL OSCILLATOR
XUL DATASHEET
DC Characteristics
(V
DD
= 2.5 V
± 5%, T
A
= - 20°C to +70°C; -40° to +85°C). Below are guaranteed for listed standard frequencies.
Parameter
Power Supply Current
Differential Output Voltage
Output Offset Voltage
Enable/Disable Input HIGH Voltage
(Output enabled)*
Enable/Disable Input LOW Voltage
(Output disabled)
Symbol
I
DD
V
OD
V
OS
V
IH
V
IL
Condition
Standard frequencies
Std LVDS load
Std LVDS load
Min
0.25
1.0
70%V
DD
Typ
75
0.45
1.17
Max
90
0.55
1.375
Units
mA
V
V
V
30%V
DD
V
* A pullup resistor from pin 6 (VDD) to pin 1 (E/D) enables output when pin 1 is left open.
AC Characteristics
(V
DD
= 2.5 V
± 5%, T
A
= - 20°C to +70°C; -40° to +85°C). Below are guaranteed for listed standard frequencies.
Note: Inclusive of initial frequency accuracy, operating temperature range, supply variation, load variation, 3 times solder reflow, shock, vibration and 1 year aging at 25°C. We do not
recommend hand soldering the devices
IDT XO LVDS CRYSTAL OSCILLATOR
4
REVISION B 12/15/14
XUL DATASHEET
DC Characteristics
(V
DD
= 1.8 V
± 5%, T
A
= - 20°C to +70°C; -40° to +85°C). Below are guaranteed for listed standard frequencies.
Parameter
Power Supply Current
Differential Output Voltage
Output Offset Voltage
Enable/Disable Input HIGH Voltage
(Output enabled)*
Enable/Disable Input LOW Voltage
(Output disabled)
Symbol
I
DD
V
OD
V
OS
V
IH
V
IL
Condition
Standard frequencies
Std LVDS load
Std LVDS load
Min
0.25
Typ
0.4
1.17
Max
65
0.5
Units
mA
V
V
V
70%V
DD
30%V
DD
V
* A pullup resistor from pin 6 (VDD) to pin 1 (E/D) enables output when pin 1 is left open.
AC Characteristics
(V
DD
= 1.8 V
± 5%, T
A
= - 20°C to +70°C; -40° to +85°C). Below are guaranteed for listed standard frequencies.
Note: Inclusive of initial frequency accuracy, operating temperature range, supply variation, load variation, 3 times solder reflow, shock, vibration and 1 year aging at 25°C. We do not
Hello everyone, we have a project at hand, the transmission distance is 10m, we need to send 64B data, through the zigbee wireless module, it is required to complete the transmission in 10ms, secondly...
[i=s]This post was last edited by dcexpert on 2017-10-16 21:13[/i] When I was testing, I just touched L1 with a multimeter and it fell off. Fortunately, I found it and can solder it back on. I hope th...
When it comes to power supply testing, the first things that come to mind are ripple testing, overload testing, and dynamic slope. For DC power supplies, the best test method for evaluating DC purity ...
[table][tr][td]I recently started a project that requires a square wave phase shift circuit. I have been working on it for more than a month but have not made any progress. I am so worried! ! ! ! The ...
Have you received the product you purchased with the "coupon"? Mine is still in the processing status, and the shipping date is still empty! What is everyone's status?...
1 Introduction
The high temperature tester is mainly used for temperature tracking measurement and data acquisition during the heating process. By systematically analyzing the test data, the...[Details]
Battery life is critical for portable applications. For applications such as smoke detectors, security devices, and thermostats, factory-installed batteries need to last for more than 10 years. The...[Details]
Problems such as the depletion of natural resources, air pollution, traffic congestion, and rising fossil fuel prices have forced societies and individuals to seek alternative means of transportati...[Details]
In today's body control module (BCM) designs, savvy engineers are moving away from electromechanical relays whenever possible. Their next step is to eliminate fuses. But is eliminating fuses a nece...[Details]
Motors, especially those with brushes, generate a lot of noise. This noise must be dealt with if the appliance is to meet the requirements of EMC standards. The means to solve EMC are nothing more ...[Details]
The TPS92210 is a single-stage LED lighting pulse width modulation (PWM) controller. The TRIAC dimmable solution not only regulates the LED current, but also achieves a power factor close to 1. The...[Details]
Today, with energy becoming increasingly scarce, the utilization of natural energy has become the focus of people's attention. Among various natural energies, the endless solar energy is highly fav...[Details]
Only a small number of LED manufacturers can produce high-quality LEDs. For applications that are only used for simple indication, low-quality LEDs are sufficient. However, high-quality LEDs must...[Details]
1. Introduction
With the increasing popularity of fully automatic washing machines, consumers have higher and higher requirements for their environmenta...[Details]
0 Introduction
Ultrasonic waves
are mechanical waves with a frequency of more than 20KHz, and the propagation speed in the air is about 340 m/s (at 20°C). Ultrasonic waves can be gene...[Details]
Analysis of the three core aspects of digital TV transmission standards
According to the differences in regionality, transmission method and modulation method, the transmission method needs to...[Details]
LED is the abbreviation of the English word. Its main meanings are: LED = Light Emitting Diode, a solid-state semiconductor device that can convert electrical energy into visible light. It can dire...[Details]
introduction
At present, the research on micron and nanotechnology is very active, which has led to the rapid development of microtechnology and micro-mechanical electronic system (MEMS) t...[Details]
Car lights, whether headlights, fog lights or tail lights, play an important role in driving safety. However, the material of the car lights determines that the probability of damage in a collision...[Details]
Currently, the commonly used solar cell technologies include monocrystalline silicon solar cells and polycrystalline silicon thin-film solar cells. Production process: Monocrystalline silicon solar...[Details]
RF/Wirelessly
京公网安备 11010802033920号
EEWORLD
