HVRW21T14.32G1%

Because the STM32 HAL library only has millisecond-level delay for HAl_Delay(), in order to achieve accurate microsecond-level delay, Systick has to be modified. However, since it is used internally ...[Details]

1. Test environment description Hardware platform: NUCLEO-F767ZI development board (STM32F7, Cortex-M7, 216MHz, 2MB Flash, 512KB SRAM)  Operating system: FreeRTOS v9.0.0 (CMSIS-RTOS v1.02)  TCP/IP p...[Details]

In the development of artificial intelligence, talent reserve is undoubtedly an important part. Artificial intelligence should be a bottom-level technology that can be deeply embedded in any indust...[Details]

From last year to now, competition in the photovoltaic inverter industry has become increasingly fierce. In addition to the introduction of new products, various marketing and promotion methods hav...[Details]

This routine is also a classic routine on the development board. I modified the framework of the program to make it more suitable for future calls. The specific 4*4 keyboard scanning principle is rel...[Details]

In the project, CPLD is needed to complete part of the algorithm design. The parameters are given by AVR, so the communication between AVR and CPLD needs to be completed. Therefore, a test program is...[Details]

    This paper combines embedded control technology with network control technology to realize the design of temperature control system based on single chip microcomputer through Internet control. Th...[Details]

The analog watchdog of the ADC is used to check if the voltage is out of bounds. It has two upper and lower bounds, which can be set in the registers ADC_HTR and ADC_LTR respectively. The library fun...[Details]

Here is the temperature added in the previous chapter The above figure is the temperature calculation formula: where Vsense is the ADC value collected from the temperature channel. The stm32f407 ...[Details]

This program sets the LED running light and the 0-16 numbers of the 0th position of the digital tube to light up in a cycle. The digital tube program cannot be put into the main function, because the...[Details]

T1 or T2 are two timers/counters of MCS-51 microcontroller. The first method can use two timers/counters to generate rectangular waves. In order to save interface resources, the second method is used...[Details]

****************************************************************** 1. The operand is in register, R0--R7 2. Operands are in internal RAM 3. Operands are in external RAM But they are all similar. For ...[Details]

#include "MSP430x24x.h" void main(void) {         // Stop watchdog timer to prevent time out reset         WDTCTL = WDTPW + WDTHOLD; //Watchdog            P4DIR = BIT0|BIT1|BIT2|BIT3; //Set to outpu...[Details]

/********************************************************************** **                                                        ** File : EEPROM.c | Eeprom write and read |                         ...[Details]

1.GCC+PN(WinAVR-20071221) Introduction: WinAVR-20071221 comes with Programmer's Notepad, which is an easy-to-use and powerful code editor with basic functions such as project management, syntax colo...[Details]