SB1660

For 80,000 ZTE (000063.SZ) employees and more Chinese ICT (information and communication technology) industry practitioners, the news from across the ocean on the evening of April 16 kept t...[Details]

In the actual project development process, we often need to get the running time of a section of code. The usual method is to use an oscilloscope to measure it. This blog post will use SysTick to acc...[Details]

Using Systick timer to achieve delay 1. SysTick timer characteristics The SysTick timer is a 24-bit down counter, that is, when vlue is decremented to 0, an interrupt is triggered and the load va...[Details]

Security PPP is a new model of urban video surveillance projects: 1) The government and social capital establish a project company in a certain proportion; 2) The project company participates in the ...[Details]

Timing and protocol are two key points in digital system debugging, and they are also where logic analyzers can play their most valuable role. How can we use a logic analyzer to quickly complete wiri...[Details]

This program uses the eight-channel ADC single acquisition mode. According to the configuration, ADC12SC will automatically reset after the conversion is completed in the single mode, so it is necess...[Details]

    1. Introduction to MC68K CPU     The MC683xx series of microcontrollers are composed of the famous MOTOROLA 32-bit microprocessors such as MC68K, 68020, 68040, and the compatible 68K, CPU32, CPU3...[Details]

Use the STM32 timer input capture module to control 3-way ultrasonic sensors. The  ultrasonic sensor used this time is the common HC-SR04, which is often used in the obstacle avoidance system of smal...[Details]

If you do not use an external crystal on the STM32, the connection method of OSC_IN and OSC_OUT If you use the internal RC oscillator instead of an external crystal, please follow the following metho...[Details]

1. Common knowledge about DMA.  1. Function: to achieve high-speed data transmission between chips. That is, it can achieve data transmission without occupying the CPU.  2. Mode: There are three tran...[Details]

1. What is PWM      What is PWM? Professionally speaking, it is pulse width modulation. In layman's terms, it is the continuous output of high and low levels. For example, the microcontroller outputs...[Details]

/* Unfortunately, it cannot generate a standard 38kHz frequency square wave, there is a little error*/  #include reg51.h #define uchar unsigned char #define uint unsigned int  sbit Waveout=P1^0; //P...[Details]

As shown in the figure, the circuit is required to count and display the number of times the button is pressed. When the button is pressed once, the count value increases by 1 (it is required to accu...[Details]

Title: Use two dynamic digital tubes to display from 0 to 60, output from the P1 port of 89C51, without adding a decoder, and directly connect the digital tubes. Note that they are dynamic digital tu...[Details]

The chip is EM78P153  ; P64, P65 are connected to the crystal oscillator, the oscillation mode is 4MHz crystal oscillator  ; the watchdog is off, the instruction cycle is 2 CLOCK, and P63 is the rese...[Details]