I need help with the initialization program of the TT50 communication module and the C language program for sending and receiving text messages. The TT50 is controlled by a single-chip microcomputer. ...
Live broadcast time: October 29, 10:00-11:30Live broadcast topic: ST data center and communication network power management solutionsSpeech document: Click here to downloadWatch replay: Click to watch...
I have used PADS to package the device and would like to print it out for comparison.I only know how to use CAM to print layer by layer. How can I print the pads and silk screen together to form a com...
I am currently adjusting the SD card (2.0 protocol) driver. Its read and write speed is very slow, writing about 200KB/s, and reading is about 2-3 times faster than writing. The communication mode I a...
[i=s] This post was last edited by sipower on 2019-1-2 21:20 [/i] [align=left][font=宋体]【[/font]NXP Rapid IoT Review】+NO.1 First Hands-On Experience---Small but Complete[/align] [align=left][font=宋体]It...
TD-SCDMA terminal conformance test includes three types of tests: RF index test (reference standard: 3GPPTS34.122), protocol signaling test (reference standard: 3GPPTS34.123) and other tests (refer...[Details]
0 Introduction to the direct method of feedback linearization based on dynamic equilibrium state theory
The basic idea of the direct method of feedback linearization based on dynamic equilib...[Details]
Compared with traditional light sources, light-emitting diodes (LEDs) have many advantages, such as low operating voltage, high energy efficiency, small size and directional light. They can provide...[Details]
DC regulated power supply is a commonly used electronic device, which can ensure stable output voltage when the grid voltage fluctuates or the load changes. A low ripple, high-precision regulated p...[Details]
To help improve DC/DC conversion efficiency at lighter loads and higher frequencies, Schottky diodes can be integrated into MOSFET chips to form a single package to reduce power dissipation in the ...[Details]
IPTV (Internet Protocol TV or Interactive Personal TV), also known as interactive network television, is a new technology that uses broadband network infrastructure, takes home televisions or comp...[Details]
Most
embedded
systems are powered from a 48V backplane. This voltage is typically stepped down to a lower intermediate bus voltage of 24V, 12V, or 5V to power the circuit board racks withi...[Details]
Industrial control
often requires multi-channel fault detection and multi-channel command control (this multi-task setting is very common). A single CPU chip is difficult to directly complete ...[Details]
Abstract: This paper introduces the controller, interface, display principle and driving method of the handheld computer LCD display based on the SA1110 microprocessor. Combined with the HPC projec...[Details]
Nowadays, the phenomenon of using cloned taxis and trucks for operation is becoming more and more serious. The so-called cloned car is one or several unlicensed vehicles that are used to copy anoth...[Details]
0Introduction
Microactuators, as driving components of microelectromechanical systems (MEMS), have been widely studied. In recent years, actuators made of hard magnetic and soft magnetic m...[Details]
Today, the value of electronic components in cars accounts for 15-20% of the total vehicle. In the future, as more safety electronic devices, fuel consumption and fuel emission control electronic s...[Details]
Analysis of automotive sensor testing requirements
At present, the control system used in automobiles can be functionally divided into three parts: sensor unit, control unit and execution ...[Details]
With the increasing application of various nonlinear loads, reactive power and harmonic pollution in the power grid have become a very serious problem. In order to eliminate the pollution caused by...[Details]
1 Introduction
With the development of information industry and microelectronics technology, the functions of embedded systems are becoming more powerful and the structures are becoming mo...[Details]