Ruthenium oxide dielectric offers superior resistance
to the elements.
3) Electrodes not corroded by soldering
Thick film makes the electrodes very strong.
4) Leading the world in development and mass produc-
tion.
Since start of production in 1982 (first in the wold), this
component has established a solid reputation as a
general–purpose chip resistor.
5) ROHM resistors have approved ISO–9001 certifica-
tion.
Design and specifications are subject to change with-
out notice. Carefully check the specification sheet be-
fore using or ordering it.
!Ratings
Item
Rated power
Conditions
Power must be derated according to the power derating curve in
Figure 1 when ambient temperature exceeds 70
°C
.
100
80
60
40
20
0
Specifications
0.125W (1 / 8W)
[0.100W (1 / 10W)]
∗
at 70°C
POWER LOAD (%)
– 55
0
70
100
155
AMBIENT TEMPERATURE (°C)
Fig.1
Rated voltage
The voltage rating is calculated by the following equation. If the value
obtained exceeds the maximum operating voltage, the voltage rating
is equal to the maximum operating voltage.
E: Rated voltage (V)
E = P× R
P: Rated power (W)
R: Nominal resistance (Ω)
Nominal resistance
Operating temperature
* At power rating of 0.1W, maximum overload voltage and maximum intermittent overload voltage are 300V.
Max. operating voltage
150V
200V
(300V)
∗
Max. overload voltage
Max. intermittent overload voltage 200V
(300V)
∗
See Table 1.
– 55
°C
to + 155
°C
MCR10
Resistors
Jumper type
Resistance
Rated current
Peak current
Max. 50mΩ
2A
10A
J ( ± 5%)
Table 1
Resistance tolerance
F ( ± 1%)
Resistance range
(Ω)
10
≤
R
≤
2.2M (E24,96)
1.0
≤
R
<
2.2
2.2
≤
R
<
10
10
≤
R
<
10M
(E24)
(E24)
(E24)
Resistance temperature coefficient
(ppm /
°C)
± 100
500 ± 350
± 500
± 200
Operating temperature – 55°C to + 155°C
!Before
using components in circuits where they will be exposed to transients such as pulse loads (short–duration, high– level loads), be certain to evaluate the
component in the mounted state. In addition, the reliability and performance of this component cannot be guaranteed if it is used with a steady state voltage that
is greater than its rated voltage.
MCR10
Resistors
!Characteristics
Characteristics
DC resistance
Resistance temperature
characteristics
Short time overload
±
(2.0% + 0.1Ω)
Specifications
Chip resistance
Jumper type
F:
±
1%
J:
±
5%
Max. 50mΩ
Test method
JIS C 5202 5.1
Applied voltage: A
JIS C 5202 5.2
Test conditions: + 25 / – 55 / + 25 / + 125°C
JIS C 5202 5.5
Rated voltage (current):
×
2.5, 5s.
Maximum overload voltage: 200V
JIS C 5202 5.6
Test voltage: 100V, 1min.
Assembled state
Metal block
observation
point A
Insulation plate
See Table 1.
Max. 50mΩ
Min. 1,000MΩ between terminal and board
Insulation resistance
Test resistor
Metal plate
Observation Insulation
sheath
R 0.5
point B
Spring-loaded
pressure
Withstand voltage
Do not damage insulation or cause a short circuit.
±
(5.0% + 0.1Ω)
JIS C 5202 5.7
Test voltage: 500V
JIS C 5202 5.8
Rated voltage (current):
×
2.5
(1s: ON – 25s: OFF)
×
10,000cyc.
JIS C 5202 6.1
JIS C 5202 6.4
Soldering conditions: 260
±
5°C
Soldering time: 10
±
1s.
JIS C 5202 6.5
Rosin methanol: (25%WT)
Soldering conditions: 235
±
5°C
Soldering time: 2.0
±
0.5s.
JIS C 5202 7.2
155°C
Test time: 1,000 to 1,048 hrs.
JIS C 5202 7.10
Rated voltage (current), 70°C
1.5h: ON – 0.5h: OFF
Test time: 1,000 to 1,048 hrs.
JIS C 5202 7.9
Rated voltage (current), 60°C, 90%RH
1.5h: ON – 0.5h: OFF
Test time: 1,000 to 1,048 hrs.
JIS C 5202 7.5
85°C, 85%RH
Test time: 1,000 to 1,048 hrs.
JIS C 5202 7.4
Test temperature: – 55°C to + 125°C 100cyc.
JIS C 5202 6.9
Room temperature, static immersion, 1 min.
Solvent: Isopropyl alcohol
Intermittent overload
Terminal strength
(against bending of circuit board)
Resistance to soldering heat
Max. 50mΩ
±
(1.0% + 0.05Ω)
Max. 50mΩ
There must be no mechanical damage.
±
(1.0% + 0.05Ω)
Max. 50mΩ
Outside must not be noticeably damaged.
95% of terminal surface must be covered by
new soldering, and there must be
no soldering corrosion.
Solderability
Resistance to dry heat
±
(3.0% + 0.1Ω)
Max. 100mΩ
Endurance
(under load in damp environment)
±
(3.0% + 0.1Ω)
Max. 100mΩ
Endurance
(steady state)
±
(3.0% + 0.1Ω)
Max. 100mΩ
Resistance to humidity
(steady state)
±
(3.0% + 0.1Ω)
Max. 100mΩ
Temperature cycling
±
(1.0% + 0.05Ω)
Max. 50mΩ
Resistance to solvents
Max. 50mΩ
±
(0.5% + 0.05Ω)
Markings must not be dissolved away.
MCR10
Resistors
!External
dimensions
(Units: mm)
0.4 ± 0.2
No.
0.4 ± 0.2
2.0 ± 0.1
0.55 ± 0.1
Material
Thick dielectric glaze of ruthenium
(only silver used for jumper)
Thick film of palladium-silver for primary electrode
Nickel-coated secondary electrode
External electrode coated with tin and lead
Alumina substrate
1.25 ± 0.1
Overcoating
!Packaging
Reel
Taping
P
0
P
2
P
1
φD
0
E
F
B
0
08
06
04
02
02
04
06
08
W
A
B
D
A
0
Heat crimp cover/Tape
Thick paper (Underside paper tape) Chip resistor Square punchout hole
I have a file in the middle, but I don't know what to open. I can't post it here. If you understand, please contact me. I am an expert in microcontrollers....
I encountered a problem. I am using the SerialPort class. After opening the port, the first time I send "AT" the DataReceived event does not trigger. No matter how long I wait, it will only be trigger...
Nowadays, dishwashers have become a must-have appliance in many home kitchens. So how do dishwashers control the water level?
A photoelectric water level sensor is installed in the dishwasher. When th...
This circuit is part of the AGC circuit, and VG1 is the output voltage of the AGC. VF3 is used to adjust the circuit gain to control the size of VG1. Due to my limited ability, I cannot do theoretical...
I use the YL2410 development board s3c2410 of Youlong Company, but I installed the BSP of magic2410 of Zhou Ligong Company because the BSP provided by YL2410 is modified from wince4.2 version, and it ...
Most of the houses we live in now are elevator buildings, mainly because it is more convenient to go up and down the stairs! It can also make life more comfortable. It even helps to increase the ad...[Details]
"Have you set your calendar reminder?"
On August 24, Nvidia Robotics' official account posted a photo of a black gift box on a social media platform, with an attached greeting card sig...[Details]
Long ago, the lifespan of cars in my country was 15 years. Once a car reached 15 years old, it was forced to be scrapped. However, the policy was later changed. As long as the car does not exceed 6...[Details]
Limited vocabulary recognition
According to the number of characters, words or short sentences in the vocabulary, it can be roughly divided into: less than 100 is small vocabulary; 100-1000 is...[Details]
On August 25th, TSMC, the world's leading contract chip manufacturer, attracted significant attention for its decision to build a chip manufacturing facility in Arizona. TSMC primarily manufactures...[Details]
Core point: The automotive industry chain and the humanoid robot industry have collaborative advantages in hardware, software, and scenarios. Upstream and downstream companies in the automotive ind...[Details]
On August 21, WeRide officially launched WePilot AiDrive, a one-stage end-to-end assisted driving solution developed in cooperation with Bosch. This comes only half a year after the two parties' "t...[Details]
Since the beginning of this year, price wars have intensified, new models have been launched one after another, used cars with zero kilometers have become a hot topic, and the industry's internal c...[Details]
On August 22, according to the Ministry of Industry and Information Technology's official website, my country's first mandatory national standard for the control of hazardous substances in electric...[Details]
While the current industry consensus is that autonomous vehicles are robots and that their systems are managed using robotics-developed thinking, there are also cases where autonomous driving is ac...[Details]
Pure electric vehicles, structurally speaking, have components such as a power battery. In addition to the power battery, a small battery also powers some low-voltage electrical components and even...[Details]
With the advent of the electric car era, the number of pure electric vehicles has increased significantly, but many car owners do not know how to properly maintain pure electric vehicles. In additi...[Details]
Tires are a very important component for cars. They are related to the driving experience of the vehicle. We are almost inseparable from cars in our daily lives. For tires, according to the role of...[Details]
With the increasing popularity of automated equipment, linear modules, a common auxiliary device for automated equipment, have also seen a bright future. In particular, in recent years, many small ...[Details]
As the range of electric vehicles continues to increase, driving electric vehicles for long-distance travel has become a trend. For high-speed travel, how much impact will high-speed driving of ele...[Details]
Integrated technical exchanges
京公网安备 11010802033920号
EEWORLD
