GRF22N2EWALN

On April 19, it was reported that Alibaba DAMO Academy is developing a neural network chip, Ali- NPU , which is mainly used for AI reasoning calculations such as image and video analys...[Details]

     The day before yesterday, I learned about STM's Systick and found it quite useful for precise timing. When I used CVAVR before, I found that the delay.h in it was very useful. So, I used STM32's...[Details]

UART has three operation modes: polling mode, interrupt mode and DMA mode. Chip: STM32F103C8T6 Application Pin: Output: PA0, PA1 USART1 Configuration interface Add interrupt configuration Add DMA...[Details]

background After the hardware engineer completed the PCB and schematic design, the routine was modified according to the tutorial of Zhengdian Atom to verify the correctness of the hardware.  STM32F...[Details]

Function List and Notes (lower-level driver part) 1. IO port initialization: control IO and communication IO. Control includes power control, reset and low power mode. Communication is the serial po...[Details]

As a leading company in automotive semiconductors, Freescale and Khronos Group have jointly launched an automotive multimedia embedded microprocessor i.MX35 with an integrated OpenVG hardware acceler...[Details]

I used the bit definition in my 51 program: bit flag. After defining it this way, I ran the program and downloaded it to the circuit board. I found that the flag was not the value I set, which led to...[Details]

The analog watchdog of the ADC is used to check if the voltage is out of bounds. It has two upper and lower bounds, which can be set in the registers ADC_HTR and ADC_LTR respectively. The library fun...[Details]

The Vatican Secret Archives is one of the world's greatest historical collections, but many of its documents have never been transcribed. Recently, a project called Codice Ratio used a combination...[Details]

Interrupts and timers implement a 24-hour clock. The program is as follows: #include reg52.h   #define PORTLEN P0   sbit bit_select = P2^0; sbit seg_select = P2^1;   unsigned char src = {0x3f,0x06,0...[Details]

T1 or T2 are two timers/counters of MCS-51 microcontroller. The first method can use two timers/counters to generate rectangular waves. In order to save interface resources, the second method is used...[Details]

Requirements: Set timer T1 as an external event counter, count 500 pulses every time, then switch T1 to timing mode and output a positive pulse with a width of 10ms at P1.2. Over and over again. A...[Details]

　　According to a report by Russian News Agency on November 23, Alexander Hanin, founder and general manager of VisionLabs, a Russian facial recognition software development company, believes that in ...[Details]

Pay attention to whether the new lock matches the old door 　　Smart locks have many advantages over traditional mechanical locks. Although the domestic penetration rate is not high, with the strength...[Details]

Mobile phone battery charger program made by STC12C2052AD microcontroller #include  stc12c2052ad.h   #include  intrins.h   #define uchar unsigned char  #define uint unsigned int sbit REF   =P1^0; sbi...[Details]