CTH6VF-222K

Dong Yang, executive vice president of the China Association of Automobile Manufacturers, said on the 26th that according to the authorization of the Ministry of Industry and Information Technology...[Details]

1. Problem When developing STM32 with IAR, I found that I could not print floating point numbers by redirecting printf to the serial port. The code is as follows:  The output is as follows:  It can...[Details]

Hardware platform: stm32F407Zet6 Software platform: stm32cubeMX 4.7+MDK5.14 Circuit connection: PE8-LED0, PE9-LED1, PE10-LED2, PE11-LED3 Step 1: Create a project using stm32cubeMX 1. Start the soft...[Details]

I used STM32CubeMX V4.22.1 to generate a project including EHT and Lwip. The debugging has been abnormal. After careful inspection, the following problems were found: 1. The hardware uses LAN8720A, b...[Details]

What is SYSTICK: This is a 24-bit system tick timer, SysTick, with automatic reload and overflow interrupt functions. All microcontrollers based on the Cortex_M3 processor can obtain a certain time ...[Details]

Independent watchdog (IWDG) and low power mode are often used in STM32 development. The watchdog is to detect and solve faults caused by software errors, and the low power mode is to enter sleep mode...[Details]

Introduction: As a power electronic device, the photovoltaic inverter mainly converts the direct current generated by the photovoltaic module into alternating current. Because there are thousands o...[Details]

The clock system of STM32 can be directly summarized in a diagram (from the STM32F10X reference manual).  The following is an analysis of this diagram 1. STM32 input clock source 1.1 Function of cl...[Details]

/*----------------------------------------------------------------------                             TMOD (89H)                     T1 T0       GATE C/T` M1 M0 GATE C/T` M1 M0 -----------------------...[Details]

;The hardware connection circuit of the 51 single-chip microcomputer is as follows: ;P1.3 and P1.4 are each connected to a button; ;P0.0 and P0.3 are each connected to a light-emitting diode; ;P2.0~P...[Details]

Code: void TEST(volatile near unsigned char* IO,unsigned char n,BOOL value) { unsigned char  a; unsigned char  b; a=*IO; b=0x01; b=b n; if(value) { *IO=a | b; } else { b=~b; *IO=a & b; } } PIC stru...[Details]

Homemade LED Electronics   Clocks can be seen in many electronic newspapers and magazines, but most of them need to reset the time and other parameters after power failure, which brings a lot of inco...[Details]

    This design is intended to take advantage of the above favorable conditions and propose an image acquisition solution based on the TMS320C6x11 series DSP. By taking advantage of the uniformity of...[Details]

"When the spring breeze blows, the horses gallop." This is a true portrayal of the development of NB-IoT (Narrowband Internet of Things) in China and even the world in the past two years. Le...[Details]

In this example, a single-byte binary number (0X20) is converted into uncompressed BCD code and stored in 0X25, 0X24, and 0X23, where 0X25 is the hundreds place and 0X23 is the ones place. main: MOV ...[Details]