Information contained herein is deemed reliable and accurate as of the issue date. EMCORE reserves the right to change the design or specification at any time without notice.
EMCORE is a registered trademark of EMCORE Corporation in the U.S. and other countries.
Information contained herein is deemed reliable and accurate as of the issue date. EMCORE reserves the right to change the design or specification at any time without notice.
EMCORE is a registered trademark of EMCORE Corporation in the U.S. and other countries.
3998 Series 1550 nm
Externally-Modulated Transmitter
DATASHEET | OCTOBER 2013
CATV
S-Type
Property
Performance
(Note 1-7)
Specified Link Length
Channel Plan
Optical Output Power
Noise Bandwidth
SBS Suppression
Carrier to Noise Ratio
Composite Second Order
Composite Triple Beat
Composite Triple Beat
Po (dBm)
BW (MHz)
(dBm)
CNR (dB)
CSO (dBc)
CTB (dBc)
CTB (dBc)
L (km)
Units
3998-
SA1
65
NTSC 80
7.0/ 7.0
4
16.0
53.0/ 53.0
-65/ -65
-65
-64
Models
3998-SA2
65
PAL 60
7.0/ 7.0
5
16.0
53.0/ 53.0
-65/ -65
-65
-64
Comments
3998-SA4
65
PAL 89
7.0/ 7.0
5
16.0
50.0/ 50.0
-65/ -65
-65
-64
3998-SA3
65
NTSC 110
7.0/ 7.0
4
16.0
50.0/ 50.0
-65/ -65
-65
-64
3998-SA5
65
42 CENELEC
7.0/ 7.0
5
16.0
53.0/ 53.0
-65/ -65
-65
-64
Min.
Min.
Max.
Max. @ +25°C
Max. @ 0
o
C to 50
o
C
Min. - Higher Powers
Available See Chart
F-Type
Property
Performance (Note 1-7)
Specified Link Length
Channel Plan
Optical Output Power
Noise Bandwidth
SBS Suppression
Carrier to Noise Ratio
Composite Second Order
Composite Triple Beat
Po (dBm)
BW (MHz)
(dBm)
CNR (dB)
CSO (dBc)
CTB (dBc)
Units
3998-F01
L (km)
20
NTSC 80-Ch
7.0/ 7.0
4
21.0
48.0
-58
-58
Models
3998-F02
3998-F03
20
PAL 60-Ch
7.0/ 7.0
5
21.0
48.0
-58
-58
20
NTSC 110-ch
7.0/ 7.0
4
21.0
45.0
-58
-58
Comments
3998-F04
20
PAL 89-Ch
7.0/ 7.0
5
21.0
45.0
-58
-58
Min.
Min.
Max.
Max.
Min.
N-Type
Property
Performance (Note 1-7)
Specified Link Length
Channel Plan
Optical Output Power
Noise Bandwidth
SBS Suppression
Carrier to Noise Ratio
Composite Second Order
Composite Triple Beat
Composite Triple Beat
Po (dBm)
BW (MHz)
(dBm)
CNR (dB)
CSO (dBc)
CTB (dBc)
CTB (dBc)
L (km)
Units
Models
3998-N01
3998-N02
40
NTSC 80-Ch
9.5
4
13.0
52.0
-62
-62
-61
40
PAL 60-Ch
9.5
5
13.0
52.0
-62
-62
-61
Min.
Min.
Max.
Min.
Comments
Max. @ +25°C
Max. @ 0
o
C to 50
o
C
Notes:
1. Unless stated otherwise all specifications apply over full temperature range with no digital loading.
2. Unless stated otherwise specifications apply for nominal RF input level as defined below, after a 30 minute stabilization
3. Specifications separated by a slash are port1 / port 2.
4. Units are tested per the Test / Link Configuration Table
5. Noise figure for the EDFA = 4.5 ~ 5.5 dB
6. Corning SMF-28 single mode fiber
7. Receiver responsivity is 0.95 mA/mW, Equivalent noise current is 7 pA/(Hz)1/2General and Mechanical Specifications
8. With 36 QPSK modulated SAT-IF signals between 950 --- 2800 MHz, 27 MHz IF bandwidth.
Information contained herein is deemed reliable and accurate as of the issue date. EMCORE reserves the right to change the design or specification at any time without notice.
EMCORE is a registered trademark of EMCORE Corporation in the U.S. and other countries.
Information contained herein is deemed reliable and accurate as of the issue date. EMCORE reserves the right to change the design or specification at any time without notice.
EMCORE is a registered trademark of EMCORE Corporation in the U.S. and other countries.
Information contained herein is deemed reliable and accurate as of the issue date. EMCORE reserves the right to change the design or specification at any time without notice.
EMCORE is a registered trademark of EMCORE Corporation in the U.S. and other countries.
Digital Integrated Circuit Analysis and Design : https://training.eeworld.com.cn/course/6150Integrated circuits (ICs) are already ubiquitous, and most of them are digital ICs. This course allows you t...
This code is to detect whether there is a string t in the string s, but I don’t understand the for (t_temp = t; *t_temp == *m_temp; t_temp++, m_temp++); What is the logical sequence of this code? Plea...
ESD requires a discharge path
It is usually discharged into the ground through resistors and capacitors.However, the device has an insulation withstand voltage requirement. If the resistor and capacit...
[i=s]This post was last edited by aq1261101415 on 2022-7-15 17:51[/i]Hello everyone, I want to ask now I have two BUCK circuits, the expected output is 5V/2A and 3V3/3A, they share a common input 12V,...
Just received it at noon~ The picture above~ The packaging is very complete, not squashed by the courier~The overall feeling is not as good as the workmanship of MSP-EXP430G2, there are no foot pads, ...
In recent years, with the increasing demand for manufacturing and automated production management, industrial barcode scanners have gradually become an indispensable part of the industrial manufact...[Details]
Tesla and BYD, vying for dominance in the global electric vehicle market, are reportedly considering adopting Samsung's AMOLED (active-matrix organic light-emitting diode) technology for their next...[Details]
Flip-chip and ball grid array (BGA) are two widely used packaging technologies in the electronics industry. Each has its own advantages and limitations, and in some cases, they can complement each ...[Details]
introduction
With the development of digital and network technologies, broadcasting technology has become increasingly diversified, with the most significant trend being the transition from an...[Details]
On August 22nd, Lantu Motors unveiled a new technology called "Lanhai Intelligent Hybrid" during a live broadcast of CCTV News' "Top Laboratory." The name sounds like another new term, but a closer...[Details]
According to foreign media reports, BMW has just been granted a patent for a screen that could cover the entire roof. BMW hopes to transform at least a portion of the vehicle's headliner into a dis...[Details]
Recently, South Korean robotics giant WIRobotics launched its first general-purpose humanoid robot, ALLEX, at the Robotics Innovation Center (RIH) at the Korea University of Science and Technology....[Details]
When discussing autonomous driving technology, there are often two extremes: on the one hand, there's the vision of "fully autonomous driving," while on the other, there's concern about potential s...[Details]
introduction
As “energy conservation and emission reduction” has become an indicator of the National Economic Development Outline of the 11th Five-Year Plan, people’s awareness of green enviro...[Details]
Have you ever heard stories about "crazy appliances"? Think of microwaves that turn on automatically or ovens that preheat without any human input? With radios and electromagnetic interfaces ubiqui...[Details]
In the scorching summer, electric fans are a must-have for cooling down people's homes. However, I believe most people have encountered this situation: the fan is plugged in, the switch is pressed,...[Details]
SMT placement machines are important equipment in surface mount technology (Surface Mount Technology). Their performance has a decisive impact on the quality and efficiency of electronic manufactur...[Details]
Reflow soldering, as an electronics assembly process, has become a vital component of the electronics manufacturing industry. Choosing reflow soldering equipment is crucial for improving production...[Details]
Plug-in hybrid vehicles (PHEVs) utilize two powertrains. Their pure electric range is typically inferior to that of pure electric vehicles, often reaching less than half that. Currently, mainstream...[Details]
With the support and encouragement of national policies, some Internet car manufacturers have also joined the new energy vehicle manufacturing industry. From the perspective of new car manufacturer...[Details]
Embedded System
京公网安备 11010802033920号
EEWORLD
