I am a beginner in driver development and I followed the example to write a simple GPIO driver to control the LED on the development board. However, after dynamically loading the driver, an error was ...
I haven't played around with FPGA for a long time . I was busy moving and joining a new company recently. I only had time to play around with Gowin FPGA these days . Now I use Gowin FPGA to drive OLED...
[i=s]This post was last edited by dj狂人 on 2014-12-15 13:54[/i] [align=left] [font=宋体][size=18.0pt]System Beat[/size][/font][/align][align=left][font=宋体][size=18.0pt] [/size][/font][/align][align=left]...
As shown in the picture, similar to this warning, is renamed..., but I have set the duplicate GND and VCC pins to POWER attributes, why does it still prompt duplicates? What's going on?...
I was assigned a task to develop a PCI interface board and related drivers using PCI chips. I know a little bit about C/C++ and VC++, but not much about hardware. I only know a little bit about digita...
All electronic design engineers and scientists have performed electrical signal analysis, or signal analysis for short. Through this basic measurement, they can gain insight into signal details and...[Details]
1. Introduction
At present, most lighting equipment still uses traditional energy for lighting. Making full use of solar energy as the energy supply for lighting equipment is of great si...[Details]
Overview:
This paper introduces a method of connecting a CAN-bus network with Ethernet to form a medium-sized remote monitoring/data transmission network.
CAN (Controller Area Network) is ...[Details]
1 Introduction
Building Automation System (BAS) is a distributed monitoring system (DCS) designed according to distributed information and control theory. It is the result of the mutual de...[Details]
1 Introduction
With the development of control, computer, communication, network technology, etc., a new control technology, namely fieldbus, has emerged in the field of industrial control...[Details]
Many battery-powered systems require a visual indicator to show when the battery needs to be replaced. LEDs are commonly used for this purpose, but they consume at least 10mA of current. This con...[Details]
introduction
MEMS is a high-tech that has flourished on the basis of integrated circuit production technology and dedicated micro-electromechanical processing methods. Pressure sensors develop...[Details]
LonWorks fieldbus technology is widely used, for example, in intelligent buildings, industrial control, environmental protection, etc. Echelon's LonWorks system has been used in the products of tho...[Details]
Today's automotive application developers face numerous design challenges as modern cars add more electronic functionality, while the need for lower power consumption and smaller printed circuit bo...[Details]
1. Introduction
Stepper motor is a basic component that converts electrical energy into kinetic energy. It has been widely used in a variety of electromechanical equipment, such as various machine...[Details]
Since the implementation of the self-weight toll collection system, the highway administration has not only high requirements for the vehicle axle recognition rate, but also requires a long service li...[Details]
For the past
15
years, many have predicted that
the
8
-bit microcontroller would soon be gone. However, this was one of the most miscalculated predictions in the el...[Details]
1 Theoretical Analysis
Ultrasonic waves
When propagating in a suspension, the ultrasonic waves that encounter the suspended particles are scattered and attenuated at the interface, an...[Details]
0 Introduction
According to the definition of IEC/SC65C of the International Electrotechnical Commission, the digital, serial and multi-point communication data bus between the field equipment...[Details]
In a network-centric battlefield, all systems (platforms) are interconnected nodes that work together to provide mission-critical information to military personnel. This approach is driving the dev...[Details]