Information contained herein is deemed reliable and accurate as of the issue date. EMCORE reserves the right to change the design or specification at any time without notice.
EMCORE is a registered trademark of EMCORE Corporation in the U.S. and other countries.
Information contained herein is deemed reliable and accurate as of the issue date. EMCORE reserves the right to change the design or specification at any time without notice.
EMCORE is a registered trademark of EMCORE Corporation in the U.S. and other countries.
3998 Series 1550 nm
Externally-Modulated Transmitter
DATASHEET | OCTOBER 2013
CATV
S-Type
Property
Performance
(Note 1-7)
Specified Link Length
Channel Plan
Optical Output Power
Noise Bandwidth
SBS Suppression
Carrier to Noise Ratio
Composite Second Order
Composite Triple Beat
Composite Triple Beat
Po (dBm)
BW (MHz)
(dBm)
CNR (dB)
CSO (dBc)
CTB (dBc)
CTB (dBc)
L (km)
Units
3998-
SA1
65
NTSC 80
7.0/ 7.0
4
16.0
53.0/ 53.0
-65/ -65
-65
-64
Models
3998-SA2
65
PAL 60
7.0/ 7.0
5
16.0
53.0/ 53.0
-65/ -65
-65
-64
Comments
3998-SA4
65
PAL 89
7.0/ 7.0
5
16.0
50.0/ 50.0
-65/ -65
-65
-64
3998-SA3
65
NTSC 110
7.0/ 7.0
4
16.0
50.0/ 50.0
-65/ -65
-65
-64
3998-SA5
65
42 CENELEC
7.0/ 7.0
5
16.0
53.0/ 53.0
-65/ -65
-65
-64
Min.
Min.
Max.
Max. @ +25°C
Max. @ 0
o
C to 50
o
C
Min. - Higher Powers
Available See Chart
F-Type
Property
Performance (Note 1-7)
Specified Link Length
Channel Plan
Optical Output Power
Noise Bandwidth
SBS Suppression
Carrier to Noise Ratio
Composite Second Order
Composite Triple Beat
Po (dBm)
BW (MHz)
(dBm)
CNR (dB)
CSO (dBc)
CTB (dBc)
Units
3998-F01
L (km)
20
NTSC 80-Ch
7.0/ 7.0
4
21.0
48.0
-58
-58
Models
3998-F02
3998-F03
20
PAL 60-Ch
7.0/ 7.0
5
21.0
48.0
-58
-58
20
NTSC 110-ch
7.0/ 7.0
4
21.0
45.0
-58
-58
Comments
3998-F04
20
PAL 89-Ch
7.0/ 7.0
5
21.0
45.0
-58
-58
Min.
Min.
Max.
Max.
Min.
N-Type
Property
Performance (Note 1-7)
Specified Link Length
Channel Plan
Optical Output Power
Noise Bandwidth
SBS Suppression
Carrier to Noise Ratio
Composite Second Order
Composite Triple Beat
Composite Triple Beat
Po (dBm)
BW (MHz)
(dBm)
CNR (dB)
CSO (dBc)
CTB (dBc)
CTB (dBc)
L (km)
Units
Models
3998-N01
3998-N02
40
NTSC 80-Ch
9.5
4
13.0
52.0
-62
-62
-61
40
PAL 60-Ch
9.5
5
13.0
52.0
-62
-62
-61
Min.
Min.
Max.
Min.
Comments
Max. @ +25°C
Max. @ 0
o
C to 50
o
C
Notes:
1. Unless stated otherwise all specifications apply over full temperature range with no digital loading.
2. Unless stated otherwise specifications apply for nominal RF input level as defined below, after a 30 minute stabilization
3. Specifications separated by a slash are port1 / port 2.
4. Units are tested per the Test / Link Configuration Table
5. Noise figure for the EDFA = 4.5 ~ 5.5 dB
6. Corning SMF-28 single mode fiber
7. Receiver responsivity is 0.95 mA/mW, Equivalent noise current is 7 pA/(Hz)1/2General and Mechanical Specifications
8. With 36 QPSK modulated SAT-IF signals between 950 --- 2800 MHz, 27 MHz IF bandwidth.
Information contained herein is deemed reliable and accurate as of the issue date. EMCORE reserves the right to change the design or specification at any time without notice.
EMCORE is a registered trademark of EMCORE Corporation in the U.S. and other countries.
Information contained herein is deemed reliable and accurate as of the issue date. EMCORE reserves the right to change the design or specification at any time without notice.
EMCORE is a registered trademark of EMCORE Corporation in the U.S. and other countries.
Information contained herein is deemed reliable and accurate as of the issue date. EMCORE reserves the right to change the design or specification at any time without notice.
EMCORE is a registered trademark of EMCORE Corporation in the U.S. and other countries.
As shown in the figure below, the resistor of 100Ω has a length of 34mm and a middle diameter of 8mm.
The words on the resistor body seem to be:S91RX21-0100R JWhat's the power of this resistor?Thanks!...
For STM32, there are two ways to reset the software: 1) Use the official software library The system reset function is directly provided in the stm32f10x_nvic.c file of the official software li...[Details]
CMSIS Driver has similar API functions and similar calling methods. It is a further encapsulation based on the ST HAL library. It is much more convenient and simpler to use and configure than the ST ...[Details]
All relevant units:
In accordance with the relevant requirements of the provincial and municipal electric vehicle charging infrastructure construction work, in order to further standardize the...[Details]
In recent years, in order to meet the needs of social development, more and more companies have entered the fields of smart phones, artificial intelligence,
VR
, AR, etc. After seeing the d...[Details]
Notes on inverter installation and maintenance:
1. Before installation, you should first check whether the inverter is damaged during transportation.
2. When selecting an installa...[Details]
STM32 has 2 watchdogs: independent watchdog and window watchdog. Independent watchdog IWDG: A system fault detector that is independent of the system and is not affected by the system because it has ...[Details]
The calculation formula of the watchdog feeding time (watchdog overflow time) is: Tout=((4*2^prer)*rlr)/40 Tout is the watchdog overflow time (in ms), prer is the watchdog clock prescaler value (...[Details]
Ouster LiDAR OS-1 (left) and OS-2 (center) Velodyne invented the modern 3D LiDAR scanner in the mid-2000s, but in recent years conventional wisdom has held that Velodyne’s design — 64 lasers mounted...[Details]
When STM32 uses JTMS (PA13) and JTCK (PA14) as normal I/O ports, add the following code before initialization (the order cannot be reversed): RCC_APB2PeriphClockCmd(RCC_APB2Periph_AFIO, ENABLE); G...[Details]
Note: This STM32 microcontroller is the STM32F103 series. The ADC of Stm32 has DMA function. This is beyond doubt and is what we use most! However, if we want to sample a signal (such as a pulse sign...[Details]
Table of contents: 1 Overview 2: Common interrupt functions 3: PWM output 1 Overview In development, timers are widely used, which can be simply summarized into three aspects: 1.1: Application of ...[Details]
;The hardware connection circuit of the 51 single-chip microcomputer is as follows: ;P1.3 and P1.4 are each connected to a button; ;P0.0 and P0.3 are each connected to a light-emitting diode; ;P2.0~P...[Details]
//Environment: winavr+avr studio char temp=0; ISR(TIMER1_COMPA_vect )//interrupt function { // user code here temp++; if (temp==10) temp=0; PORTA=temp; DDRA=0xff; } void ...[Details]
Test/Measurement
京公网安备 11010802033920号
EEWORLD
