LPEG08DR-GAR

Recently, the results of the 2018 German Red Dot Design Award were announced. GoodWe, a company located in Suzhou High-tech Zone, stood out among thousands of outstanding design products from 5...[Details]

1. Test conditions Hardware: STM32L432KC  Main frequency: 80MHz  Compiler: IAR 8.20.1  Compiler options: High Speed ​​no size constraints  CRC generator polynomial: 0x782f 2. Test Method The softwar...[Details]

The trade war between China and the United States has become the focus. The United States has begun to play the ban card against Chinese technology companies. The ZTE incident shows that if the ban...[Details]

Function List and Notes (lower-level driver part) 1. IO port initialization: control IO and communication IO. Control includes power control, reset and low power mode. Communication is the serial po...[Details]

The Wassenaar Arrangement, everything started during the Cold War. Let's learn more about it with the embedded editor. background After the end of World War II, the United States ...[Details]

The application of millimeter wave technology in mobile communications also involves a series of technical problems, including the large propagation loss of millimeter waves and the susceptibility ...[Details]

In the Huaxing Optoelectronics LCD panel factory located in Guangming New District, Shenzhen , apart from a few people repairing machines, it is often difficult to see other people. Here, ev...[Details]

This program is used in the development board to generate sounds of different frequencies. The overall program is relatively simple, mainly using two timers. The code and my comments are as follows. ...[Details]

STM32 uses FSMC to read and write CPLD programs. CPLD is hung on the address line and data line of STM32. CPLD is regarded as an off-chip RAM for reading and writing. On the board I made, CPLD is hun...[Details]

On the eve of 5G commercialization, ZTE has established and adhered to the 5G pioneer strategy, focusing on 5G end-to-end solutions, and investing in standard setting, ...[Details]

As shown in the figure, the author soldered a STM32F207VET6 board using a TQFP (32-100PIN) 0.55MM to direct plug adapter board. The board leads out the SWD debug interface (only PA13 and PA14 are occ...[Details]

#include reg52.h //Include the header file. Generally, no modification is required. The header file contains the definition of special function registers.                              /*-------------...[Details]

Single-chip microcomputer experiment design: It is required to use 8951 series single-chip microcomputer, design a pulse generator with a pulse width duty cycle of 50%, 25% adjustable, and a period o...[Details]

Requirements: Set timer T1 as an external event counter, count 500 pulses every time, then switch T1 to timing mode and output a positive pulse with a width of 10ms at P1.2. Over and over again. A...[Details]

    I have been working on single-chip microcomputers for several years, and I have always wanted to make a series of summaries. It happened to rain today. As the saying goes: Rainy days are good for...[Details]