SP2-078-S270/02-95/2

On April 24, Sungrow released its annual financial report. The report shows that in 2017, Sungrow's global shipments reached 16.5GW, of which domestic shipments reached 13.2GW, a year-on-year incre...[Details]

1. Development Environment       1. Applicable chips: All STM32F4 chips       2. Firmware library: STM32F4xx_DSP_StdPeriph_Lib_V1.8.0       3，IDE：MDK517 2. Driver source code       Delay.h...[Details]

UART has three operation modes: polling mode, interrupt mode and DMA mode. Chip: STM32F103C8T6 Application Pin: Output: PA0, PA1 USART1 Configuration interface Add interrupt configuration Add DMA...[Details]

LAN8720 configuration:  IP: 192.168.192.30  Gateway: 192.168.192.1 A high frequency of ARP packets is detected The content of the packet asks for the mac address of 192.168.192.1, and asks the resp...[Details]

After studying the F4 FSMC method to drive the touch screen for a few days, I have gained some understanding, which are listed below. The unorganized record is only for my own reference in the future...[Details]

This program mainly uses the comparison output function of the timer to generate PWM waves to control the LED. The comparison output of timer A corresponds to P2.3 P2.4. Therefore, a matching working...[Details]

    1. Brief description     A summary of "How to build uClinux kernel transplantation on ARMSYS development board with S3C44B0X as core", including the analysis of Bootloader function and the key co...[Details]

    This paper combines embedded control technology with network control technology to realize the design of temperature control system based on single chip microcomputer through Internet control. Th...[Details]

    This paper proposes a design scheme for an embedded CNC system based on ARM and FPGA. The software and hardware design of the ARM system, the implementation method of hardware fine interpolation ...[Details]

The independent watchdog of STM32 is driven by a dedicated internal 40Khz low-speed clock, that is, it is still effective even if the main clock fails. Here we need to note that the clock of the inde...[Details]

Today I am using the AD function of the stm8s microcontroller. There are ten channels from AN0 to AN9 on the microcontroller. I want to use only three of them, AN5 to AN7. //ADC initialization void A...[Details]

1. What is PWM      What is PWM? Professionally speaking, it is pulse width modulation. In layman's terms, it is the continuous output of high and low levels. For example, the microcontroller outputs...[Details]

This program sets the LED running light and the 0-16 numbers of the 0th position of the digital tube to light up in a cycle. The digital tube program cannot be put into the main function, because the...[Details]

1. A/D (Analog-to-Digital) and D/A (Digital-to-Analog) Conversion 1. Pin AOUT: Analog output Vref: reference voltage AGND: Analog ground EXT: Ground OSC: Floating SCL，SDA：IIC AIN0, AIN1, AIN2: anal...[Details]

1. SCL is always controlled by the Master. SDA is controlled by the Slave when reading data and by the Master when writing data according to the direction of data transmission. After the 8-bit data i...[Details]