-
Hardware designers have begun to adopt FPGA technology in high-performance DSP designs because it can provide 10-100 times faster computing than PC-based or microcontroller-based solutions. Previou...[Details]
-
This paper designs a dot matrix LED text display screen that is easy to update, expandable, and low-cost. The way to reduce costs is
① Use the Bluetooth data transmission function of mobile ph...[Details]
-
PV inverter manufacturer SMA has launched its first DC arc fault circuit interrupter (AFCI) PV inverter and has received UL certification.
The new SunnyBoy AFCI inverter models include 3000-US...[Details]
-
Spatial Division Multiplexing (SDM) MIMO processing can significantly improve spectrum efficiency and thus greatly increase the capacity of wireless communication systems. Spatial Division Multip...[Details]
-
LED light sources have many environmental advantages, but early products still have certain technical bottlenecks in heat dissipation and high brightness design that cannot be broken through....[Details]
-
1. Introduction
AS-Interface bus technology is an intelligent network that uses a single cable to connect sensors and actuators to controllers, transmit data, and provide power. It can be used...[Details]
-
Synchronous buck designs are becoming increasingly difficult, and the selection of suitable ICs is becoming quite narrow. This Design Idea combines a current-mode PWM IC used in a flyback regulator...[Details]
-
Inverter supplier Santerno has been awarded a contract to supply 155MW of sliding inverters to a solar farm in California’s Imperial Valley. The company did not disclose further details about the p...[Details]
-
The performance of most portable products depends on the quality of the batteries that power them. In recent years, as battery performance has improved, portable products are moving towards smaller...[Details]
-
Design Considerations
After the long-term deployment of smart meters (automatic meter reading infrastructure), a two-way communication will be established between the utility and the consumer. The ...[Details]
-
Dynamic loads present some of the most challenging problems in the power supply field. Rapidly changing currents or pulsed currents are extremely difficult to control, and many devices under test ...[Details]
-
This article focuses on systems that use electric vehicle batteries to power homes.
The driving battery of the electric car "Leaf" has a large driving battery capacity of 24kWh. When fully cha...[Details]
-
Preface
For a new antenna, we usually care about its
three main performance indicators:
standing wave
coefficient, gain and radiation pattern. In a suitable microwave darkroom, these th...[Details]
-
0 Introduction
Learning single-chip microcomputers is a very practical process. At present, single-chip microcomputer laboratories are basically built with hardware simulation equipment. Due to...[Details]
-
At present, LEDs are all driven by DC, so an LED adapter, i.e., LED driver power supply, needs to be added between the mains and the LED. Its function is to convert the AC mains into DC power suita...[Details]